Table of Contents
Advertisement
2.9.2
Chassis footpads
The barebone server system is shipped with four footpads attached to the bottom
of the chassis for stability. You need to remove these footpads if you wish to install
the system to a rack (Refer to Chapter 3: Installation options of this user guide,
and to the "Rackmount Kit" user guide for instructions)
To remove the footpads:
1.
Lay the system chassis on its side.
2.
Use a flat screwdriver to flip out the
top layer of a footpad.
3.
Remove the footpad by rotating it
counterclockwise.
4.
Repeat steps 2 and 3 to remove the other three footpads.
2-28
Chapter 2: Hardware setup
Advertisement
Table of Contents
