Cisco ASA 5510 Quick Start Manual page 42

Adaptive security appliance asa 5500 series

Hide thumbs Also See for Cisco ASA 5510:

Table of Contents

Step 6: Specify Remote Hosts and Networks.

Identify hosts and networks at the remote site to be allowed to use this IPSec tunnel to communicate

with the local hosts and networks you identified in Step 5. Add or remove hosts and networks

dynamically by clicking Add or Delete respectively. In the current scenario, for ASA 1, the remote

network is Network B (10.20.20.0), so traffic encrypted from this network is permitted through the

tunnel.

To specify a remote host or network to be allowed access to the IPSec tunnel, perform the following

steps:

Click IP Address.

Specify whether the interface is inside or outside by choosing one interface from the Interface

drop-down menu.

Enter the IP address and mask.

Click Add.

Repeat Step 1 through Step 5 for each host or network that you want to have access to the tunnel.

Click Next to continue.

Table of Contents

Show Quick Links

Table of Contents

Cisco asa 5520 Cisco asa 5540