6-1-3. Parts Location of the Tape Path System
Following figure describes the names of each part of the tape path system.
It is illustrated in the threading end mode of the recorder. " TG " in the figure means
the tape guide.
TG-3 (Exit guide)
AT erase head
AT head
TG-4
TG-6
Capstan
Pinch roller
TG-1
(S tension regulator)
TG-5 (Threading roller)
TG-0
Tape cleaner
Full-erase head
(Recorder only)
CTL head
TG-2
6-1-4. Cassette Compartment
(1) The tape path adjustment should be performed under the state that the cassette
compartment is removed. If not, some checks and adjustments may be impossi-
ble.
(2) When the tape path adjustment is performed with the cassette compartment
removed, the tape protection circuit is activated and the "ERROR" message may
be displayed. In this case, turn the power off, then turn it on again.
6-2
TG-7
TG-8
(T tension regulator)
TG-9
Drum
Slant guide
TG-10
SRW-5000/5500