Cisco 1240AG Series Quick Start Manual page 31

Hide thumbs Also See for 1240AG Series:

Table of Contents

– Repeater—Specifies that the unit operates as a repeater access point

not connected to Ethernet LAN. In this mode, wireless clients

associate to the access point.

– Root Bridge—Specifies that the unit operates as a root bridge and

connects directly to the main Ethernet LAN. In this mode, the unit

accepts associations from other Cisco Aironet non-root bridges and

wireless client devices.

– Non-Root Bridge—Specifies that the unit operates as a nonroot

bridge and connects to a remote LAN. In this mode, the unit must

associate with a Cisco Aironet root bridge using the wireless

interface. The nonroot bridge can support wireless client devices.

– Workgroup Bridge—Specifies that the unit operates as a workgroup

bridge connected to a small wired Ethernet LAN network through

an Ethernet hub or switch. The workgroup bridge must associate to

a Cisco Aironet access point or bridge.

– Scanner—Specifies that the unit is configured by a Cisco WLSE

and operates as a scanner and reports network traffic to the Cisco

WLSE.

•

Optimize Radio Network For—Optimizes the access point radio

performance in the wireless network by adjusting data rates. This setting

must match the setting on the clients.

– Throughput—Maximizes data volume handled by the access point

but might reduce its range.

Quick Start Guide Cisco Aironet 1240AG Series Access Point

Table of Contents

Show Quick Links

Table of Contents