2. A “ LASS 1 LASER PRO U T” a e is affi e to the unit fra e. otto of the ayer. CLASS 1 . S ecifications of Laser io e ecifications of laser radiation fields to hich human access is ossi le durin service. Wavelen th = 800 nanometers DEH-P3500MP/XM/EW...
Page 3
By following the instructions in this manual, be sure to apply the prescribed grease or glue to proper portions by the appropriate amount.For replacement parts or tools, the prescribed ones should be used. DEH-P3500MP/XM/EW...
Unplugging and plugging the connectors dur- ing power-on mode may damage the ICs inside the unit. 2. To protect the pickup unit from electrostatic dis- charge during serviving, take an appropriate treat- ment(shorting-solder) by referring to "the DISAS- SEMBLY" on page 51. DEH-P3500MP/XM/EW...
BRST,BRXEN,BSRQ CONT CONT BDATA,BSCK CD CONTROLLER Q752 CLAMP IC 701 PE5352B DSCSNS HOME HOME CD3VON Q751 VDCONT 12EJ DISC SENSE 8EJ SENSE CLAMP VDCONT SENSE SENSE +3.3V REGULATOR IC 203 3VDD IC 703 V3R3D BA033SFP S-818A33AUC-BGN +3.3V REGULATOR Q754 DEH-P3500MP/XM/EW...
Note: When ordering service parts, be sure to refer to “EXPLODED VIEWS AND PARTS LIST” or “ELECTRICAL PARTS LIST”. Large size SCH diagram CD:0dBs Guide page Detailed page FM:-27 AM:-27 IP-BUS:+2 CN901 CD CORE UNIT(S10MP3) IP-BUS:+2.2dBs FM(30%):-26.0dBs AM(30%):-26.0dBs EJECT PANEL UNIT DEH-P3500MP/XM/EW...
Page 15
No differentiation is made between chip capacitors and 0.022 R022 discrete capacitors. The > mark found on some component parts indicates the importance of the safety factor of the part. Therefore, when replacing, be sure to use parts of identical designation. DEH-P3500MP/XM/EW...
CD CORE UNIT S901 : HOME SWITCH..ON-OFF S902 : CLAMP SWITCH..ON-OFF S903 : DSCSNS SWITCH..ON-OFF S904 : 12EJ SWITCH..ON-OFF S905 : 8EJ SWITCH..ON-OFF The underlined indicates the original switch position. R744 SPINDLE MOTOR M1 CXB6007 M2 CXB8933 LOADING/CARRIAGE MOTOR DEH-P3500MP/XM/EW...
Page 23
CD CORE UNIT (S10MP3) R209 R207 R205 R240 SIGNAL LINE FOCUS SERVO LINE TRACKING SERVO LINE CARRIAGE SERVO LINE SPINDLE SERVO LINE MA152WA 4R7/25 & 4R7/25 PE5352B CN721 DEH-P3500MP/XM/EW...
Page 28
00m /di 0ms/di 00m /di s/di 00m /di s/di 00m /di 1 /di pindle a e orm during pindle a e orm during agni ied e e pattern e .: e .: e .: ode: ode: ode: Normal Normal Normal DEH-P3500MP/XM/EW...
Page 29
1 SCS S 5V/div 1 SCS S 1V/div /div 500m /div 5V/div /div 1V/div 5V/div 5V/div 5V/div 5V/div A a o Audio i e wave, 1 Hz 1 cm C cm C orma orma orma DEH-P3500MP/XM/EW...
Page 30
1V/div 500m /div 1V/div 500m /div 500mV/div 500mV/div 500mV/div 500mV/div Wh n witching to D- M rom D-DA Wh n witching to D-DA rom D- (BA D k y) (BA D k y) ormal ormal DEH-P3500MP/XM/EW...
CORD ASSY For further information for respective destinations, be sure to check with the schematic dia- gram. 2.Viewpoint of PCB diagrams WIRED IP-BUS Capacitor Connector REMOTE CONTROL SIDE A SIDE B Chip Part P.C.Board L981 CN901 DETACH SENSE DEH-P3500MP/XM/EW...
Page 33
SIDE A IC,Q RCA OUT ANTENNA CN1950 FRONT DEH-P3500MP/XM/EW...
6. ADJUSTMENT 6.1 JIG CONNECTION DIAGRAM RUBBER BAND CN1951 TUNER AMP UNIT PANEL UNIT (SIDE A) GGD1316 CN1901 KEYBOARD UNIT (SIDE B) RUBBER BAND DEH-P3500MP/XM/EW...
1k ohms in series. • The load and eject operation is not guarantied with the mechanism upside down. If the mechanism is blocked due to mistaken eject operation, reset the product or turn off and on the ACC to restore it. DEH-P3500MP/XM/EW...
Page 47
9) A i a i it i a i it T P(1 ) T P( N 11 N 11 As for t e dou e s eed ( ) audio out ut annot e su orted DEH-P3500MP/XM/EW...
Because of eccentricit in the disc and a slight misalignment of the clamping center the grating waveform ma be seen to "wobble" the phase difference changes as the disc rotates . The angle specified above indicates the average angle. Reloading the disc changes the clamp position and ma decrease the "wobble". DEH-P3500MP/XM/EW...
Page 49
Grating waveform 20mV/div, AC 20mV/div, AC DEH-P3500MP/XM/EW...
T C can t be read error wouldn t occur but mechanism still continues its operation. hen newly design head unit be sure to apply as the display e amples above. The upper digits of error code is mainly classified by inds as follows etup related error earch related error A ther errors. DEH-P3500MP/XM/EW...
Grille Assy. Grille Assy Fig.1 Removing the Tuner Amp Unit (Fig.2) Remove the screw. Remove the three screws. Straight the tabs at three locations indicated. Remove the screw and then remove the Tuner Amp Unit. Tuner Amp Unit Fig.2 DEH-P3500MP/XM/EW...
Page 52
4. While releasing from the hook of the inner holder, lift the end of the feed screw. eed Screw Caution: In assembling, move the planet gear to the load/eject position before setting the feed screw in the inner holder. Inner older lanet DEH-P3500MP/XM/EW...
CD LSI data output CD LSI command/data control output xrst CD : LSI reset control output xstb CD LSI strobe output ASENBO IP-BUS : Slave power supply control output Not used TEST TUNER : Signal level input STRKEY1 Steering remote controller input DEH-P3500MP/XM/EW...
Page 55
PLL data output TUNPCE PLL chip enable output Beep tone output * PE5338A Format Meaning CMOS IC's marked by * are MOS type. Be careful in handling them because they are very liable to be damaged by electrostatic induction. BD4834G Vref DEH-P3500MP/XM/EW...
Page 57
Key data output MODA Crystal oscillator connection pin Crystal oscillator connection pin 25,26 KDT2,3 Key data input Not used KST4 Key strobe output 29-32 Not used 33-55 SEG35-13 LCD segment output Power supply 57-64 SEG12-5 LCD segment output *PD6340A DEH-P3500MP/XM/EW...
Page 58
Information on error correction (mute for Lch) C2D3 Information on error correction D.GND Ground for digital circuits Output of DRAM RAS cas) Output of DRAM Lower CAS cas! Output of DRAM Upper CAS Output of DRAM WE Output of DRAM OE DEH-P3500MP/XM/EW...
Page 59
Reversal input of TE Output of TE A.GND Ground for the analog system LDREGO Output of REG voltage for APC Input of PD Output of LD Assignment of pickup polarity A.VDD Power supply for the analog system * UPD63760GJ DEH-P3500MP/XM/EW...
Page 60
Input of read-ready flag with WMA decoder DBBO0, 1 AVDD A power supply Positive power supply (5V) AVSS A power supply GND AVREF The reference voltage input for A/D converter VDSENS VD power supply short sense input DSCSNS Disc state sense input TEMP Temperature information sense input DEH-P3500MP/XM/EW...
Page 61
ROMCS E2PROM chip selection output ROMCK E2PROM clock output FRXD For flash rewriting (received signal) FTXD For flash rewriting (transmitted signal) AO/DO The output for Analog/Digital voice output distinction P-Bus serial data input * PE5352B Format Meaning CMOS MSM51V4265EP-70TS DEH-P3500MP/XM/EW...
Page 62
22 AUDIOGND audio ground Ground of audio block 23 L ch O L channel output FM stereo “L-ch” signal output or AM audio output 24 R ch O R channel output FM stereo “R-ch” signal output or AM audio output DEH-P3500MP/XM/EW...
In case of the above signal, the communication with Grille microcomputer may fail. Source keys If the time interval is not 300msec, the oscillator operative may be defective. Source ON SYSPW←H Pin 21 Completes power-on operation. (After that, proceed to each source operation) DEH-P3500MP/XM/EW...
7.4 CLEANING Before shipping out the product, be sure to clean the following portions by using the prescribed cleaning tools: Portions to be cleaned Cleaning tools CD pickup lenses Cleaning liquid : GEM1004 Cleaning paper : GED-008 DEH-P3500MP/XM/EW...
Page 68
1. Attach the holders to both sides of the front panel. Holder CND1250 Holder CND1249 2. Replace the front panel to the unit. 3. Flip the holders into upright positions. 4. Fix the front panel to the unit using fixing screws. Fixing screw BPZ20P060FZK DEH-P3500MP/XM/EW...