The product supports PC image resolutions up to XGA (1024ð768) with a vertical frequency of 85HZ. b. General specification z Model name: 42EP24S Number of pixel: 852(H)h480(V) (1Pixel= 1 RGB Cells) z Pixel pitch: 1080µmh1080µm z Cell Pitch: 320µm(H) x 1080µm(V) (Base: Green Cell) z Display area: 920.1(H) x 518.4(V)±0.5mm...
2. Safety Precautions When servicing of PDP Module, it should be not enforced into another way aside next rule, or a unaccustomed person should not repairing. When using/handling this PDP Module, pay attention to the below warning and cautions. Warning Indicates a hazard that may lead to death or injury if the warning is ignored and the product is handled incorrectly.
Page 5
charged at the moment of Power OFF, standing by for 1 minute is required in order to touch the Device circuitry. 2) CAUTIONS (1) Do not place this product in a location that is subject to heavy vibration, or on an unstable surface such as an inclined surface. The product may fall off or fall over causing injuries.
Page 6
(27) Use of the product with a combination of parameters conditions or logic not specified in the specifications of this product is not guaranteed. If intending to use the product in such a way, be sure to consult HAIER in advance.
c. Power specification (1).Output voltage (2). Micro Controller control signal Input signal(to PSU): RLY signal ( High : Low Voltages*1are ON Low : Low Voltages are OFF) VS ON signal (High : High Voltages*2are ON Low : High Voltages are OFF) Output signal(from PSU) ACD signal (High : 75V <...
b: CHIP SUMMARY M30620: 16-BIT CMOS SINGLE-CHIP MICROCOMPUTER The single-chip microcomputer operate using sophisticated instructions featuring a high level of instruction efficiency. With 1M bytes of address space, they are capable of executing instructions at high speed. In addition, this microcomputer contains a multiplier and DMAC which combined with fast instruction processing capability.
C: Debug flow-chart AC ON Whether alternating current Power board: input STANDBY +5V FOUND Initialization: System Reset Power On *Repair power board. Power failure *Replace fuse. +9V +12V +5V *Check dc-dc circuit +2.5V +3.3V +1.8V and LDO circuit. FOUND SvpEx E0 error SvpEx Reset Svpex E0 Good *SvpEx no ack.
Page 26
PRELIMINARY DV009_2: SVP-EX(256) + SAA7117A + HDMI- Block Diagram TUNER OPTION 4M X32 PC RGB PC_HS/VS Differential TV_PIP Output LVDS SVP-EX SVIDEO_1 Output 16-bit Data SAA7117A CVBS_TV PQFP256 HS, VS, CLK SCART RGB VIDEO CVBS_OUT 2Vp_p FLASH ADDRESS[18:0] MEMORY MAIN BOARD TV AND M30620SPGP...
Page 27
C306 C308 C310 C313 C315 C317 C319 C311 100nF 100nF 100nF 100nF 100nF 100nF 100nF 100nF Connector for Amtel AT76C112 Video Output if not a test pad, an enlarged via VDDMQ VDDM underneath the chip or exposed trace. Possible DQS MCLK exposed trace, DQ enlarged via E_PWM C305...
Page 33
TP20 TP21 TP22 TP23 TP24 TP25 TP26 TP27 A[0..7] A[0..7] RP30 33Rx4 RP32 33Rx4 RP34 33Rx4 When use 27C040,use R144 and RP35 33Rx4 RP31 33Rx4 R140;R145 and R147 are Option. When use W29C040,use R145 and R147;R140 and R144 are Option. R136 100R RX_INT#...