Signal Strength And Coverage - Cisco 8800 Series Deployment Manual

Wireless lan deployment guide

Hide thumbs Also See for 8800 Series:

Table of Contents

Non-overlapping channels must be used and allow at least 20 percent overlap with adjacent channels when deploying the Cisco

IP Phone 8800 Series in the 802.11b/g/n environment, which allows for seamless roaming.

Using an overlapping channel set such as 1, 5, 9, 13 is not a supported configuration.

Signal Strength and Coverage

To ensure acceptable voice quality, the Cisco IP Phone 8800 Series should always have a signal of -67 dBm or higher when

using 2.4 GHz or 5 GHz, while the Cisco IP Phone 8800 Series also meets the access point's receiver sensitivity required signal

level for the transmitted data rate.

Ensure the Packet Error Rate (PER) is no higher than 1%.

A minimum Signal to Noise Ratio (SNR) of 25 dB = -92 dBm noise level with -67 dBm signal should be maintained.

It is recommended to have at least two access points on non-overlapping channels with at least -67 dBm signal with the 25 dB

SNR to provide redundancy.

To achieve maximum capacity and throughput, the wireless LAN should be designed to 24 Mbps. Higher data rates can

optionally be enabled for other applications other than voice only that can take advantage of these higher data rates.

Recommended to set the minimum data rate to 11 Mbps or 12 Mbps for 2.4 GHz (dependent upon 802.11b client support

policy) and 12 Mbps for 5 GHz, which should also be the only rate configured as a mandatory / basic rate.

In some environments, 6 Mbps may need to be enabled as a mandatory / basic rate.

Due to the above requirements, a single channel plan should not be deployed.

Cisco IP Phone 8800 Series Wireless LAN Deployment Guide

Table of Contents