Advertisement
Quick Links
Advertisement
Related Manuals for Cisco Linksys E2100
Summary of Contents for Cisco Linksys E2100
- Page 1 Linksys E2100 Router Setup Guide...
- Page 2 Configure QoS Settings (MAC Method) Log in to the router. The default IP address is 192.168.1.1. The default username is “admin”. The default password is “admin”. Click the Applications & Gaming tab. For field descriptions, click Help on the right side of the screen. Select QoS.
- Page 3 In the field labeled “Upstream Bandwidth”, select “Manual” from the drop-down menu and enter your current upload speed. (If unsure of your current upload speed, please run a speed test at http://www.megapath.com/speedtestplus/. Select “MAC Address” from the drop-down menu labeled “Category”.
- Page 4 You will need the MAC address for each IP device to continue. In the field labeled “Enter a Name”, enter a unique name for the device for which you will prioritize traffic. Polycom VVX 500 In the field labeled “MAC Address” enter the MAC address for the device. Polycom VVX 500...
- Page 5 In the field labeled “Priority”, select “High” from the drop-down menu. Polycom VVX 500 Click “Apply” to save changes. Polycom VVX 500...
- Page 6 Repeat steps 6-10 until you have entered all of the IP phones. When all have been entered and you see them in the “Summary” section, click on “Save Settings”. Polycom VVX 500 Polycom VVX 500 Polycom VVX 500 Polycom VVX 500 Power cycle/reboot the router before proceeding.
- Page 7 Configure QoS Settings (MAC Method) Log in to the router. The default IP address is 192.168.1.1. The default username is “admin”. The default password is “admin”. 2. Click the “Applications & Gaming” tab. Select “QoS”. Select the radial button “Enabled” next to the field labeled “Internet Access Priority”.
- Page 8 In the field labeled “Upstream Bandwidth”, select “Manual” from the drop-down menu and enter your current upload speed. (If unsure of your current upload speed, please run a speed test at http://www.megapath.com/speedtestplus/. In the “Category” section, select “Applications” from the drop-down menu.
- Page 9 In the field labeled “Applications”, select “Add a New Application” from the drop-down menu.
- Page 10 Enter a unique name in the “Enter a Name” field. Enter the following port ranges and select “UDP” from the drop-down menu to the right of each port range field and set the priority to “High” on the drop-down menu: 5060-5090, 8000-8200, 16384-16482. MegaPath...