Table of Contents
Advertisement
Configuring Phone Settings
To reach the Settings menu, press the centre Select button, scroll to Settings, and press the Select button again. In the
Settings menu, press the arrow buttons to select the settings you want to change and press the Select button. You can
perform the following tasks:
Ringtones:
Tones:
is parked.
Backlight Settings:
before it is turned off to conserve battery power.
Date/Time:
the date and time manually from the handset.
Handset Settings:
in the upper right corner of the display. The handset name is used to identify
the SPA302D with the Intercom and handset deregistration.
Factory Reset:
Performing a factory reset removes all of the information from your handset (for
example, contacts, speed dials, and call records) and restores it to the original factory software
state. The Cisco SPA302D remains registered to the Cisco SPA232D after a factory reset, and
must be manually deregistered.
Phone Info:
Information can be viewed such as Software version, IP Address, MAC Address, etc.
Handset Registration & Update Software is described in detail below
Pair the handset with the base station
Described below is the process to associate the SPA302D handset to the SPA232D base station. This would be used if an
extra handset is purchased.
Registering the handset / Steps
On the Cisco SPA302D handset, press the Select button in the centre
of the 4-way navigation keypad
Using the navigation arrow buttons, scroll to the Settings icon and
select it.
Select Handset Registration.
Select Register.
On the Cisco SPA232D, press the Page/Registration button and hold
it down for at least seven seconds until the green status light flashes
quickly.
Enter the PIN code. By default, there is no PIN code (leave it blank). Then press the left softkey to confirm that you want
to register the handset. The "registering" message appears.
Note 1:
To verify that the handset is registered to the base station, confirm that the DECT signal strength icon is solid (not
flashing) and that the handset ID, such as Handset 1 (or Handset 2), appears near the top right corner of the display screen.
Note2:
In case that the batteries are removed from the handset or go dead the handset will still be registered on the base
station
Flip Solutions Ltd t/a Flip Connect
Phone: 020 3056 5060 | Fax: 0870 421 5411 | E-Mail: sales@flipconnect.co.uk
There are 5 different ringtones. For private contacts the user can select a different melody
You can configure a tone to play when keys on the handset are pressed or when a phone call
You can configure the amount of time that the handset display screen remains lit
The handset date and time is synchronized with the Cisco SPA232D. You can also enter
A unique handset name can be defined which is reflected
User Guide | Cisco 232D & 302D
| 02/07/2014
5
- Quick Links:
- How to Set up the Polycom...
Hide quick links:
Advertisement
Table of Contents
