Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for DeWalt DC013-XE
Summary of Contents for DeWalt DC013-XE
- Page 1 INSTRUCTION MANUAL DC013-XE HEAVY-DUTY WORK SITE CHARGER/RADIO...
-
Page 3: Definitions: Safety Guidelines
9. Do not defeat the safety purpose of the grounding-type plug. A grounding type Definitions: Safety Guidelines plug has three blades, the third is the grounding prong. The third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an The definitions below describe the level of severity for each signal electrician for replacement of the obsolete outlet. -
Page 4: Extension Cords
equipment off and on, the user is encouraged to try to correct the interference by one MINIMUM GAUGE FOR CORD SETS or more of the following measures: For Cable length (m): 7.5 • Reorient or relocate the receiving antenna. Use Cable with minimum rating (Amperes) •... - Page 5 • Do not charge or use battery in explosive atmospheres, such as in the SPECIFIC SAFETY INSTRUCTIONS FOR NICKEL CADMIUM (NiCd) OR NICKEL presence of flammable liquids, gases or dust. Inserting or removing the battery METAL HYDRIDE (NiMH) from the charger may ignite the dust or fumes. •...
- Page 6 Labels on Charger and Battery Pack Discard the battery pack with due care for the environment. In addition to the pictographs used in this manual, the labels on the charger and the battery pack show the following pictographs: Do not incinerate the battery pack Read instruction manual NiMH, NiCd+ and Li-Ion.
-
Page 7: Important Safety Instructions For All Battery Chargers
Important Safety Instructions for All Battery Chargers • An extension cord must have adequate wire size (AWG or American Wire Gauge) for safety. The smaller the gauge number of the wire, the greater the SAVE THESE INSTRUCTIONS: This manual contains important safety and operating capacity of the cable, that is 16 gauge has more capacity than 18 gauge. -
Page 8: Grounding Instructions
Charge Indicators DC013-XE The charger/radio is designed to detect certain problems that can arise with battery packs. Problems are indicated by the red light flashing at a fast rate. If this occurs, re-insert battery pack into the charger/radio. -
Page 9: Important Charging Notes
2. The charger/radio and battery pack may become warm to touch while charging. original pack is defective and should be returned to a service center or other collection site for recycling. If the new battery pack elicits the same trouble indication as the This is a normal condition, and does not indicate a problem. - Page 10 COMPONENTS (FIG. 1, 2) FIG 1 A. Power/Volume control B. Tuning dial C. Arrow buttons D. Mode button E. Clock button F. Memory buttons G. LCD display H. Battery compartment latch I. Charging receptacle J. Charging light K. Auxiliary port L.
- Page 11 TO INSTALL COIN CELL BATTERY Method 2: Turn the tuning dial (B) clockwise to move up the frequency band. Turn the tuning dial counterclockwise to move down the frequency band. WARNING: Danger of explosion if battery is incorrectly replaced. When replacing To Seek: battery, replace it with the same or equivalent type CR2032.
- Page 12 MAINTENANCE 4. AM reception will most likely be clearer when powered by a battery pack. 5. To use the auxiliary port (K), plug the output jack from a CD or iPod */MP3 ® Service Notes player into the port (Fig. 1). The sound from the external source plays through This product is not user serviceable.
- Page 13 For warranty repair information, call (AUS) 1800 654 155 or (NZ) 0800 339258. This warranty does not apply to • Accessories • Damage caused where repairs have been made or attempted by others. • Damage due to misuse, neglect, wear and tear, alteration or modification. This warranty gives you specific legal rights and you may have other rights under the provisions of the Consumer Guarantee Act 1993 (New Zealand only), Trade Practices Act 1974 and State Legislation (Australia only).
- Page 16 20 Fletcher Road, Mooroolbark, VIC 3138 Australia (03 8720 5100) • 5 Te Apunga Place, Mt Wellington, New Zealand (0800 339258) (DEC09) Part No. N031868 DC013-XE Copyright © 2009 D WALT The following are trademarks for one or more D WALT power tools: the yellow and black color scheme;...