Table of Contents
Advertisement
Adjusting the Quick Shoot™
Control
If there is more than 1/2 inch (13 mm) of slack in the
Quick Shoot cable (Figure 37) or the discharge chute
does not rotate left and right in equal angles, adjust the
Quick Shoot control cables.
1. 1/2 inch (13 mm) maximum slack
1. Loosen the two Quick Shoot control cable clamps
(Figure 38).
1. Cable clamps
2. Position the Quick Shoot control between the two
arrows located on the right hand side of the upper
handle (Figure 39).
Figure 37
Figure 38
1. Arrows
3. Rotate the discharge chute so that it faces straight
ahead and the arrow on the back of the discharge
chute aligns with the arrow on the shroud (Figure 40).
4. Hold the discharge chute in the straight-ahead
position, pull the lower cable casing downward until
you remove the slack in the cable, and tighten the
screw on the lower cable clamp securely (Figure 41).
18
Figure 39
Figure 40
Hide quick links:
Advertisement
Table of Contents
