Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Zanussi ZWG 7160 P
Summary of Contents for Zanussi ZWG 7160 P
- Page 1 User manual Washing Machine ZWG 7160 P...
-
Page 2: Table Of Contents
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Personalisation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 Frost precaution _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 11 Environment concerns _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4... - Page 3 not pressing the electrical supply cable against the • The detergent dispenser drawer is provided with an in- wall. sert for liquid detergent. Do not use the insert down- wards for gelatinous detergents, with programmes in- • Install the appliance on a flat hard floor. cluding prewash, with the delay start option.
-
Page 4: Frost Precaution
To activate this device, ro- To disable this device and tate the button (without restore the possibility of pressing it) inside the closing the door, rotate the door clockwise until the button anti-clockwise until groove is horizontal. If the groove is vertical. necessary use a coin. -
Page 5: Product Description
>PP<=polypropylene • The machine works more economically if it is fully loa- This means that they can be recycled by disposing of ded. them properly in appropriate collection containers. • With adequate pre-treatment, stains and limited soiling can be removed; the laundry can then be washed at a Ecological hints lower temperature. -
Page 6: Installation
Electrical connection Information on the electrical connection is given on the rating plate, on the Voltage - Overall power - Fuse inner edge of the appliance door. Water supply pressure Minimum 0,05 MPa Maximum 0,8 MPa Maximum Load Cotton 6 kg Spin Speed Maximum 1600 rpm... - Page 7 • Open the door and re- Warning! Do not re- move the plastic hose move the drain hose guide, the bag contain- from the rear support. Re- ing the instruction move this hose only if it is booklet and the plastic necessary to drain the wa- plug caps from the ter.
- Page 8 Positioning and levelling 35° 45° Loosen the ring nut to angle the hose to the left or right depending on the position of your water tap. Do not place the inlet hose downwards. After positioning the inlet hose, be sure to tighten the ring nut again to pre- vent leaks.
- Page 9 If your drain hose looks like this (see beside) you do not require the “U” piece”. Just push the hose firmly in to the standpipe. • Directly to a built-in drain pipe in the room wall. Push the drain hose onto the spigot and secure with a clip, ensure a loop is formed in the drain hose to pre- vent waste from the sink entering the appliance.
-
Page 10: First Use
In the interest of the environment Electrical connection The appliance should be connected to the FOUL drainage • The appliance must be earthed. system, the water will then be taken to a sewage works for • Make sure that the electrical information on the rating treatment before being discharged safely into a river. -
Page 11: Daily Use
After pressing button 9: it will be impossible to By pressing these 2 buttons again, the acoustic signal change any other programme or option. is reactivated. To enable or disable this Child safety lock option press simultane- This device permits you to leave the appliance unattended ously for about 6 seconds so you do not need to worry that children might be injured buttons 2 and 3 until on... - Page 12 Open the door by carefully pulling the door handle • powder detergents for all types of fabric, outwards • powder detergents for delicate fabrics (40°C max) and woollens, Load the laundry • liquid detergents, preferably for low temperature wash programmes (60°C max) for all types of fabric, or spe- Place the laundry in the cial for woollens only.
- Page 13 UP- Flap position if using DOWN - Flap position if • Rotate the flap down- POWDER detergent using LIQUID detergent wards. during main wash • Carefully put the drawer back. • Measure out the detergent. For the quantity of detergent, refer always to what is written on the product packing and ensure that If the flap is not in the desired position: the detergent can be poured in the drawer.
- Page 14 Set your washing programme The control panel permits to select a washing programmes and different options. When an option button is selected, the corresponding pilot light is on. Otherwise it is off. For compatibility among washing programmes and options, see the "Washing Programmes". If an incorrect op- tion is selected, the integrated red pilot light of the button 9 flashes 3 times and the display shows the message Err.
- Page 15 Temperature button Push the temperature button to select the most suitable temperature for washing your laundry. Cold: Cold wash. Spin reduction By selecting a programme, the appliance proposes automatically the maxi- mum spin speed provided for that programme. 1600 Press this button repeatedly to change the spin speed, if you want your laun- dry to be spun at a different speed.
- Page 16 Display The display shows the following information: 7.1 Delay Start icon 7.2 Child safety lock This device permits you to leave the appliance unattended during it's func- tioning. • Duration of the selected programme After selecting a programme, the duration is displayed in hours and mi- nutes (for example ).
- Page 17 Cancelling the Delay Start after having started the programme: • Set the appliance to PAUSE by pressing button 9. • Press button 8 once. On the display will appear • Press button 9 again to start the programme. • The selected delay can be changed only after selecting the washing programme again.
-
Page 18: Washing Programmes
At the end of the programme the door frame (for more details read " Child safety" in the chapter "Safety Information"). The appliance stops automatically. The pilot light of the button 9 and the pilot light 10 go off. The display shows Stand by : during programme setting up and once the pro- gramme has finished, if the programme selector dial and If a programme or an option that ends with water left in the... - Page 19 Programme - Maximum and Minimum Temperature - Cycle De- Detergent Com- scription - Maximum Spin Speed - Maximum Fabrics Load - Type Options partment of Laundry COTTONS ECONOMY 60° - 40° Main wash - Rinses - Maximum spin speed at 1600 rpm SPIN REDUCTION Max.
- Page 20 Programme - Maximum and Minimum Temperature - Cycle De- Detergent Com- scription - Maximum Spin Speed - Maximum Fabrics Load - Type Options partment of Laundry RINSE Rinse - Short spin speed at 700 rpm. If a spin speed higher than 700 rpm is selected, by pressing the relevant button, the appliance SPIN REDUCTION performs a long spin.
-
Page 21: Consumption Values
Programme - Maximum and Minimum Temperature - Cycle De- Detergent Com- scription - Maximum Spin Speed - Maximum Fabrics Load - Type Options partment of Laundry JEANS 60°- Cold SPIN REDUCTION Main wash - Rinses - Maximum spin speed at 900 rpm RINSE HOLD Max. - Page 22 The pump must be cleaned regularly. To clean the filter, proceed as follows: • turn programme selector dial to position • unplug the appliance; • open the door; • turn the drum and align the filter cover (FILTER) with the arrow on the •...
-
Page 23: What To Do If
Cleaning the water inlet filters • if necessary, place the filter cover in the right Important! If the appliance doesn't fill, it takes a long time position again. to fill with water, the starting button flashes red or the display (if available) shows the relevant alarm (see chapter •... - Page 24 Fault code and malfunction Possible cause / Solution The water tap is closed. • Open the water tap. The inlet hose is squashed or kinked. • Check the inlet hose connection. The filter in the inlet hose or the inlet valve filter are blocked. •...
- Page 25 Malfunction Possible cause / Solution The plug is not properly inserted in the power socket. • Insert the plug into the power socket. There is no power at the socket. • Please check your domestic electrical installation. The main fuse has blown. •...
- Page 26 Malfunction Possible cause / Solution The transit bolts and packing have not been removed. • Check the correct installation of the appliance. The appliance is not levelled correctly. The appliance vibrates noisi- • Adjust the feet. The laundry is not evenly distributed in the drum. •...
- Page 27 Model description (MOD.) ....... Product number (PNC) ........Serial number (S.N.) ........Mod..Prod. No..Ser. No..
- Page 28 www.zanussi.com/shop...