D-Link DES-3010F Command Line Interface Manual page 84
Managed 8/16/24-port 10/100mbps n-way fast ethernet switch
Hide thumbs
Also See for DES-3010F:
- Manual (225 pages) ,
- User manual (225 pages) ,
- Command line interface manual (187 pages)
Table of Contents
Advertisement
config syslog host
Parameters
Restrictions
Example usage:
To configure a syslog host:
DES-3000 Series Layer 2 Switch CLI Reference Manual
Numerical
Facility
Code
0
kernel messages
1
user-level messages
2
mail system
3
system daemons
4
security/authorization messages
5
messages generated internally by syslog
6
line printer subsystem
7
network news subsystem
8
UUCP subsystem
9
clock daemon
10
security/authorization messages
11
FTP daemon
12
NTP subsystem
13
log audit
14
log alert
15
clock daemon
16
local use 0 (local0)
17
local use 1 (local1)
18
local use 2 (local2)
19
local use 3 (local3)
20
local use 4 (local4)
21
local use 5 (local5)
22
local use 6 (local6)
23
local use 7 (local7)
local0 Specifies that local use 0 messages will be sent to the remote host. This
corresponds to number 16 from the list above.
local1 Specifies that local use 1 messages will be sent to the remote host. This
corresponds to number 17 from the list above.
local2 Specifies that local use 2 messages will be sent to the remote host. This
corresponds to number 18 from the list above.
local3 Specifies that local use 3 messages will be sent to the remote host. This
corresponds to number 19 from the list above.
local4 Specifies that local use 4 messages will be sent to the remote host. This
corresponds to number 20 from the list above.
local5 Specifies that local use 5 messages will be sent to the remote host. This
corresponds to number 21 from the list above.
local6 Specifies that local use 6 messages will be sent to the remote host. This
corresponds to number 22 from the list above.
local7 Specifies that local use 7 messages will be sent to the remote host. This
corresponds to number 23 from the list above.
udp_port <int> Specifies the UDP port number that the syslog protocol will use
to send messages to the remote host.
ipaddress <ipaddr> Specifies the IP address of the remote host where syslog
messages will be sent.
state [enable | disable] Allows the sending of syslog messages to the remote
host, specified above, to be enabled and disabled.
Only Administrator-level users can issue this command.
80
- Quick Links:
- Introduction
- Connecting to the Switch
Hide quick links:
Advertisement
Table of Contents
