Table of Contents
Advertisement
5. CORRECT USE
5-6. Threading the gimp
Remove the work clamp plates (refer to page 24), and then thread the gimp as shown in the illustration below.
Once threading is complete, replace the work clamp plates.
0884Q
<-00, -01>
<-02, -52>
0886Q
5-7. Setting the material
q
w
0889Q
1. Insert the material so that it touches the right and left cloth guides q.
2. The sewing margin can be adjusted to within 10 - 30 mm.
3. Loosen the screws w at left and right and move the cloth guides q back and forth to adjust the sewing margin.
28
q
Pass the gimp through the hole
of the thread tension stud q.
Refer to "9-17. Adjusting the gimp length after trimming (-02, -52)" (Page 63).
q
w
w
DH4-B981
q
10 - 30 mm
w
0885Q
0890Q
- Quick Links:
- List of Error Codes
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
