1. ACCESSING THE WEB UI WEB UI To access the Web UI of the DWR-116, connect your computer to the DWR-116 using the ethernet cable provided. Then connect the power cable to the DWR-116. Then simply open a browser window and enter the IP address in the browser address field: IP ADDRESS: http://192.168.0.1...
Page 3
2. SETUP 3G/4G/LTE CONNECTION 3G / 4G / LTE WAN Connection Once you have successfully accessed the Web UI of the DWR-116 you will need to go to the following location to configure your 3G/4G/LTE connection settings. SETUP > INTERNET Click on the Internet Connection Setup Wizard button to start the wizard, below we will go through the required settings to setup a 3G/4G/LTE connection.
Page 4
If you are unsure of the correct details please refer to the table on the next page for the most common settings for ISPs. Once you have entered the correct details for your connection click Next. DWR-116...
Page 6
2. Cont... 3G / 4G / LTE WAN Connection Click on Connect to make the changes effective immediately. You should now have an active Internet Connection and see a similar screen as shown above. DWR-116...
- Press and hold the reset button on the rear of the device for 10 seconds. The reset process will take up to 60 seconds to complete before you can access the DWR-116 again. Note: Resetting the router to factory default will erase the current configuration settings. To re- configure your settings, log into the router as outlined in question 1, then run the Setup Wizard.