Attaching The Cable Guide - Cisco Catalyst 2970 Hardware Installation Manual
Hide thumbs
Also See for Catalyst 2970:
- Hardware installation manual (162 pages) ,
- Manual (19 pages) ,
- Product support bulletin (6 pages)
Table of Contents
Advertisement
Chapter 2
Switch Installation
Attaching the Cable Guide
Figure 2-16
Attaching the Cable Guide on the Catalyst 2970 Switch
SYS T
RPS
STA T
DU PLX
SPE ED
MO DE
1
1
Cable guide screw
OL-6422-01
After the switch is mounted in the rack, you need to do these tasks to complete the
installation:
Power on the switch. See the
•
page
2-8.
Connect to a 10/100 or 10/100/1000 port and run Express Setup. See the
•
Catalyst 2970 Switch Getting Started Guide for instructions
Connect to the front-panel ports. See the
•
Ports" section on page 2-27
page 2-30
to complete the installation.
For configuration instructions about using the CLI setup program, go to
Appendix C, "Configuring the Switch with the CLI-Based Setup Program."
We recommend attaching the cable guide to prevent the cables from obscuring the
front panel of the switch and the other devices installed in the rack. Use the
supplied black screw shown in
right bracket.
1
2
3
4
5
6
1X
7
8
9
10
11
12
11X
13X
2X
12X
14X
"Verifying Switch Operation" section on
and the
"Connecting to SFP Modules" section on
Figure 2-16
to attach the cable guide to the left or
13
14
15
16
17
18
19
20
21
22
23
24
Ca tal ys t 29
23X
70
SER IES
24X
Catalyst 2970 Switch Hardware Installation Guide
Installing the Switch
"Connecting to the 10/100/1000
2-19
Advertisement
Table of Contents
