Caution : Read this section carefully to ensure safe operation. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. G-EQ300 (En/K) VOLTAGE SELECTOR AC 220 - 240V ‘...
In case of difficulty ... 24 Specifications ... 25 System control cord (1) * AC plug adaptor (1) Introduction G-EQ300 (En/K) & carefully to ensure safe operation. * Use to adapt the plug on the power cord to the shape of the wall outlet.
Any mounting of the appliance should follow the manufacturer’s instructions, and should use a mounting accessory recommended by the manufacturer. An appliance and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the appliance and cart combination to overturn. G-EQ300 (En/K)
Page 5
1. Item 3 is not required except for grounded or polarized equipment. 2. Item 17 and 18 are not required except for units provided with antenna terminals. 3. Item 17 complies with UL in the U.S.A. IMPORTANT SAFEGUARDS G-EQ300 (En/K)
Caution against contact revitalizer Do not use contact cleaners because it could cause a malfunction. Be specially careful against contact cleaners containing oil, for they may deform the plastic componente. G-EQ300 (En/K)
Press in the genre mode to select the desired music genres and their equal- izer patterns. Frequency keys (F1, F2, F3) Each key can store a desired center frequency. ¡ FREQUENCY JOG knob Rotate the control knob to adjust the frequency band (range). G-EQ300 (En/K)
When connecting the audio cords (cords with pin plugs on each end), insert the white plugs into the L (Left) jacks and red plugs into the R (Right) jacks. G-EQ300 (En/K) ¢...
About the system control connections When this unit is connected to KENWOOD audio component system “SERIES 21”, also connect them through the system control cords to allow system-control operations between components. Connection example SYSTEM CONTROL CONTROL CENTER POWER AMPLIFIER SYSTEM...
1 Graphic equalizer display mode 2 Spectrum analyzer display mode DISPLAY 3 DEMO(Demonstration) mode : Keys and control used in the operations described on this page. 1.5k 2.5k 3.9k 6.3k Peak hold level 1.5k 2.5k 3.9k 6.3k G-EQ300 (En/K) 16 k 16 k...
: Keys and control used in the operations described on this page. Each press switches the display modes as follows. 1 Graphic equalizer display mode 2 Spectrum analyzer display mode DISPLAY 3 DEMO(Demonstration) mode Demonstration is performed repeatedly in the following order. DISPLAY GRAPHIC PARAMETRIC REFERENCE MANUAL Display G-EQ300 (En/K)
: Keys and control used in the operations described on this page. “EQ.ON” Lights up. EQ. ON 1 MANUAL 2 REFERENCE “EQ.ON” indicator goes off. ¶The pattern being displayed remains the same. 1.5k 2.5k 1.5k 2.5k G-EQ300 (En/K) “MANUAL” Lights up. MANUAL 3.9k 6.3k 16 k 3.9k 6.3k 16 k...
1 MANUAL 2 REFERENCE Select by pressing one of preset keys 1 to 5. ¶The pattern being displayed remains the same. Operation of graphic equalizer G-EQ300 (En/K) “EQ.ON” Lights up. EQ. ON “REFERENCE” Lights up. REFERENCE “EQ.ON” indicator goes off.
DISPLAY 3 DEMO(Demonstration) mode Each press switches the display as follows. 1 GRAPHIC 2 PARAMETRIC : Mode for creating a curve according G-EQ300 (En/K) “EQ. ON” Lights up. EQ. ON : Mode for adjusting equalizer curves. to center frequencies. “PARAMETRIC” Lights up.
Page 16
1 WIDE : Curve with a gentle slope. 2 NARROW: Curve with a sharp slope. WIDE NARROW WIDE NARROW 1.5k 2.5k 1.5k 2.5k G-EQ300 (En/K) One the two shall light up. 3.9k 6.3k 16 k 3.9k 6.3k 16 k &...
3 DEMO(Demonstration) mode Each press switches the display as follows. 1 GRAPHIC 2 PARAMETRIC: Mode for creating a curve according Creation of desired equalizer patterns G-EQ300 (En/K) “EQ. ON” lights up. EQ. ON : Mode for adjusting equalizer curves. to center frequencies.
¶Up to five patterns can be preset in the same manner. ¶When a pattern has previously been preset under the numeric key pressed, the newly preset pattern replaces the previous pattern. Creation of desired equalizer patterns G-EQ300 (En/K) “MEMORY” Lights up. MEMORY MEMORY...
Five of the genre keys are also used as pattern No.keys. PATTERN key FUSION/4 CLASSIC/5 MOVIE ¶After the tone pattern has been selected, characters “USE” appears on the display. Creation of desired equalizer patterns G-EQ300 (En/K) EQ. ON MANUAL 1.5k 2.5k 3.9k 6.3k...
: For use in recording of tapes to be played on car stereos. : For use in recording of tapes to be played on headphone stereo players. 1.5k 2.5k 3.9k 6.3k 1.5k 2.5k 3.9k 6.3k G-EQ300 (En/K) 16 k 16 k...
When playing a tape which has been recorded together with the equalizer effect, set the EQ.EFFECT key to OFF. Note Note : Keys and control used in the operations described on this page. Lights up. TAPE “EQ, ON” Lights up. EQ. ON 1.5k 2.5k 3.9k 6.3k G-EQ300 (En/K) 16 k...
Press the stop key of the cassette tape deck. TAPE EQ.EFFECT Use of equalizer effect with tape : Keys and control used in the operations described on this page. Turns off. TAPE “EQ, ON” Lights up. EQ. ON 1.5k 2.5k 3.9k 6.3k G-EQ300 (En/K) 16 k...
This frequency range is related to the details of the music. When this control is moved up, super high frequency instruments, such as triangles or cymbals, are emphasized, resulting in wide sound and echoes. G-EQ300 (En/K) Book shelf Carpet Bass...
Cause ¶The power cord is plugged incompletely. ¶The system control cord is not connected. ¶The input and output connections are reversed. G-EQ300 (En/K) While pressing and holding the MEMORY key, press the MAIN POWER switch to OFF then ON again.
Power consumption ... 18 W Dimensions ... W : 400 mm (15-3/4“) Weight (net) ... 4.6 kg (10.2 lb) 1. KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without notice. Notes Notes 2.
Page 26
G-EQ300 (En/K) For the U.S.A. FCC WARNING This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.
Page 28
For your records Record the serial number, found on the back of the unit, in the spaces designated on the warranty card, and in the space provided below. Refer to the model and serial numbers whenever you call upon your dealer for information or service on this product.