Table of Contents
Advertisement
Chapter 3
Installing a Cisco 6260 with a POTS Splitter Configuration
Figure 3-11 E1 I/O Module BNC Connectors
J 1
J 5
Step 2
Connect one end of an RJ-45 cable to one of the RJ-48 receptacle connectors on the E1 I/O module. If
you have a subtended network configuration installed, this connection must be made to the E1 I/O
module in the subtending host chassis.
Note
Step 3
Connect the other end of the cable used in
Note
Repeat
Step 4
Use the procedures in this section to make IMA network connections. See the
Note
section on page 1-4
3.2.14.3 OC-3c Network Connection
OC-3c network connections are made from the OC-3c/OC-3c NI-2 card. Complete the following steps
to connect the OC-3c/OC-3c NI-2 card to the network.
Do not stare into the beam or view it directly with optical instruments.
Warning
Step 1
Verify that an OC-3c/OC-3c NI-2 card is in slot 10 of the Cisco 6260 chassis (or slot 11, if you are
installing a secondary card for NI-2 redundancy).
OL-2365-02
J 2
J 3
J 6
J 7
If unshielded cable is used for FCC Class B or EN55022 Class B compliance, the cables must
be looped through ferrites.
See
Table 2-4 on page 2-16
Verify that the pinouts of the RJ-45 cable connect transmit to receive and receive to transmit.
Step 1
through
Step 3
for each Cisco 6260 chassis, as necessary.
for more information on IMA network connections.
J 4
J 8
for cable requirements.
Step 2
to the ATM switch.
Cisco 6260 Hardware Installation Guide
Installation Procedures
"IMA Configuration"
3-17
Advertisement
Table of Contents
