Connecting Power; Installing A Dc-Input Power Supply - Cisco SCE8000 Quick Start Manual

10 gbe power supply

Hide thumbs Also See for SCE8000:

Configuration manual (262 pages)

Installation and configuration manual (248 pages)

Installation manual (51 pages)

Table Of Contents

Table of Contents

Before you connect system power or turn on the Cisco SCE 8000 chassis, you must complete this procedure:

Step 1

Remove approximately 0.75 inch (19 mm) of the covering from the end of the grounding wire using a wire-stripping

tool.

Insert the stripped end of the grounding wire into the open end of the grounding lug.

Step 2

To secure the grounding wire in place in the grounding lug, use the manufacturer recommended crimping tool.

Step 3

Step 4

Locate and remove the adhesive label from the system grounding pad on the chassis (Figure 4).

Figure 4

Installing the System Ground

FA N S

SCE 800 0-SC

TA TU S

M-E

SC M

OPT ICA L

BYP ASS

CON SOL

POR T 1

10 100

LINK

1000

ACT IVE

SCE 800 0-SC

M-E

SC M

OPT ICA L

BYP ASS

CON SOL

POR T 1

10 100

LINK

1000

ACT IVE

SCE 800 0-SI

SIP

SC E8 00

0- FA N

CT RL

ST AT US

OP TIC AL

BY PA SS

OP B- SC

Place the grounding wire lug against the grounding pad, making sure that solid metal-to-metal contact exists.

Step 5

Secure the grounding lug to the chassis using two M4 screws. Ensure that the grounding lug does not interfere with

Step 6

other hardware or rack equipment.

Step 7

To ensure adequate earth ground for the Cisco SCE8000 chassis, prepare the other end of the grounding wire, and

connect it to an appropriate grounding point at your site.