Table of Contents
Advertisement
i
5.5
RJ11 and RJ45 Data Line Protection
(Modem / Phone / Fax / Network)
Connect the incoming phone line/network cable into the "IN"
connection on the back of the PROTECT A.
Incoming phone, fax,
Incoming data line
modem line
Connect the data terminal unit (phone, fax, modem) to the
"OUT" socket.
i
5.6
Communication Connection,
Connection with USB or Serial Cable
In order to allow unsupervised shutdown of the operating
system, connect the RS232 or USB cable as shown in the
drawing.
The USB connection is automatically detected.
In this connection, note the special property of the
two additional output sockets identified with
"SURGE ONLY" (chapter 4.3 / no. 7 / pg. 19).
These are always live irrespective of the other
outputs. They are not backed up by the UPS, nor
can they be switched off using the main switch of
the UPS. It is intended for loads that should be
protected
against
necessarily need a continued power supply
(emergency power) in case of a mains failure.
Limit the power to max. 1000 W.
The data line protection supports networks with
transmission rates between 10 and 100 Mbit/s.
Data lines are not supplied with the UPS.
overvoltage
22
but
do
not
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
