Table of Contents
Advertisement
Available languages
Available languages
Viewing the TV
LC-32LE350V
TV Control button & Operation
LC-32LE350V / LC-39LE350V
+
+
1. Standby button
2. TV/AV button
3. Programme Up/Down buttons
4. Volume Up/Down buttons
, switch is used for turning the TV on or off.
LC-39LE350V
English - 8 -
Standby Notifications
1) If the TV does not receive any input signal (e.g.
from an aerial or HDMI source) for 5 minutes, the TV
will go into standby. When you next switch-on, the
following message will be displayed: "Standby Cause
No Signal" Press OK to continue.
2) If the TV has been left on and not been operated
for a while, the TV will go into standby. When you next
switch-on, the following message will be displayed.
"Standby Cause No Operation" Press OK to
continue.
Inserting the Batteries into the Remote
Lift the cover on the back of the remote upward
gently. Install two AAA batteries. Make sure to
match the + and - ends of the batteries in the
battery compartment (observe the correct polarity)
Replace the cover.
Connect Power
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
Antenna/Cable Connection
Connect the "aerial" or "cable TV" plug to AERIAL
INPUT (ANT) socket located on the back of the TV.
VGA
SPDIF
Aerial or Cable
- Quick Links:
- Connecting to a Wireless Network
Hide quick links:
Advertisement
Chapters
Table of Contents
