Table of Contents
Advertisement
Installation for MS-DOS Locally Procured Version
Installation Procedure
If you install MS-DOS Locally procured version, follow the steps below.
Operating System Installation
Insert the MS-DOS startup disk and turn on the IM-800 to perform the Setup.
As for the installation procedure, refer to the MS-DOS manual.
CD-ROM Driver Installation
As for installing MS-DOS only, the CD-ROM drive for the IM-800 is not
recognized. Therefore, by using other PC to read the CD-ROM, install the
CD-ROM driver in the IM-800 after copying the CD-ROM driver on the
floppy disk from the Driver CD-ROM for the IM-800.
Network Driver Installation
The Network Driver is provided in the form compressed in the Driver
CD-ROM for the IM-800, but MS-DOS cannot extract the compressed file.
Therefore, by using other PC to read the CD-ROM, install the Network driver
toin the IM-800 after extracting the Network driver in the Driver CD-ROM for
the IM-800.
Serial port Driver Installation
Install the file to the IM-800 from the Driver CD-ROM for the IM-800.
When using the DM-M820 with Touch Panel, follow the steps as below.
Touch Panel Driver Installation
Install the Touch Panel Driver from the CD-ROM for the DM-M820. See
page 4-49.
MSR Utility Installation
When using the DM-M820 with MSR, install the MSR Utilities from the Driver
CD-ROM for the IM-800. See page 4-51.
Rev. I
MR Series Technical Reference Manual
OS and Drivers 4-41
Advertisement
Table of Contents
Troubleshooting
