Advertisement
Quick Links
KD-LH917
Installation/Connection Manual
GET0276-002A
[EE]
ENGLISH
This receiver is designed to operate on 12 V DC, NEGATIVE ground electrical systems. If
your vehicle does not have this system, a voltage inverter is required, which can be purchased
at JVC IN-CAR ENTERTAINMENT dealers.
Parts list for installation and connection
The following parts are provided for this receiver.
After checking them, please set them correctly.
A / B
Hard case/Control panel
F
Washer (ø5)
J
Handles
INSTALLATION (IN-DASH MOUNTING)
The following illustration shows a typical installation. If you have any questions or require
information regarding installation kits, consult your JVC IN-CAR ENTERTAINMENT dealer or a
company supplying kits.
• If you are not sure how to install this receiver correctly, have it installed by a qualified
technician.
1
4
*
1
When you stand the receiver, be careful not to damage the fuse on the rear.
*
1
Removing the receiver
Before removing the receiver, release the rear section.
1
C
Sleeve
G
Lock nut (M5)
K
Remote controller
2
5
2
3
D
Trim plate
H
Mounting bolt (M5 x 20 mm)
L
Battery
•
6
3
*
2
Fit the protrusions outside the receiver.
*
2
4
1
E
Power cord
I
Rubber cushion
M
CD-ROM
(Image Converter: Wide Ver 1.2)
Do the required electrical connections.
Bend the appropriate tabs to hold
the sleeve firmly in place.
Insert the two handles, then pull
them as illustrated so that the
receiver can be removed.
0105DTSMDTJEIN
EN, RU
1 8
4
m
m
5 3
m
m
Advertisement
Related Manuals for JVC KD-LH917
Summary of Contents for JVC KD-LH917
- Page 1 INSTALLATION (IN-DASH MOUNTING) The following illustration shows a typical installation. If you have any questions or require information regarding installation kits, consult your JVC IN-CAR ENTERTAINMENT dealer or a company supplying kits. • If you are not sure how to install this receiver correctly, have it installed by a qualified technician.
-
Page 2: Electrical Connections
• Be sure to ground this receiver to the car’s chassis again after installation. Notes: • Replace the fuse with one of the specified rating. If the fuse blows frequently, consult your JVC car audio dealer. • It is recommended to connect to the speakers with maximum power of more than 50 W (both at the rear and at the front, with an impedance of 4 Ω... - Page 3 ENGLISH If your car is equipped with the ISO connector / • Connect the ISO connectors as illustrated. • From the car body ISO connector of the supplied power cord View from the lead side Connections without using the ISO connectors / Before connecting: Check the wiring in the vehicle carefully.
- Page 4 Connecting the external amplifiers / You can connect amplifiers to upgrade your car stereo system. • Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this receiver.