Ports In Authorized And Unauthorized States - Cisco Catalyst 3750-X Software Configuration Manual
Hide thumbs
Also See for Catalyst 3750-X:
- Command reference manual (1244 pages) ,
- Message manual (150 pages) ,
- Getting started manual (22 pages)
Table of Contents
Advertisement
Understanding IEEE 802.1x Port-Based Authentication
Table 11-2
Authentication Manager Commands and Earlier 802.1x Commands (continued)
The authentication manager
commands in Cisco IOS
Release 12.2(50)SE or later
authentication order
authentication periodic
authentication port-control {auto
| force-authorized | force-un
authorized}
authentication timer
authentication violation {protect |
restrict | shutdown}
show authentication
For more information, see the command reference for this release.
Ports in Authorized and Unauthorized States
During 802.1x authentication, depending on the switch port state, the switch can grant a client access to
the network. The port starts in the unauthorized state. While in this state, the port that is not configured
as a voice VLAN port disallows all ingress and egress traffic except for 802.1x authentication, CDP, and
STP packets. When a client is successfully authenticated, the port changes to the authorized state,
allowing all traffic for the client to flow normally. If the port is configured as a voice VLAN port, the
port allows VoIP traffic and 802.1x protocol packets before the client is successfully authenticated.
If a client that does not support 802.1x authentication connects to an unauthorized 802.1x port, the
switch requests the client's identity. In this situation, the client does not respond to the request, the port
remains in the unauthorized state, and the client is not granted access to the network.
In contrast, when an 802.1x-enabled client connects to a port that is not running the 802.1x standard, the
client initiates the authentication process by sending the EAPOL-start frame. When no response is
received, the client sends the request for a fixed number of times. Because no response is received, the
client begins sending frames as if the port is in the authorized state.
You control the port authorization state by using the dot1x port-control interface configuration
command and these keywords:
•
•
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
11-10
The equivalent 802.1x commands in
Cisco IOS Release 12.2(46)SE and
earlier
dot1x mac-auth-bypass
dot1x reauthentication
dot1x port-control {auto |
force-authorized |
force-unauthorized}
dot1x timeout
dot1x violation-mode {shutdown
| restrict | protect}
show dot1x
force-authorized—disables 802.1x authentication and causes the port to change to the authorized
state without any authentication exchange required. The port sends and receives normal traffic
without 802.1x-based authentication of the client. This is the default setting.
force-unauthorized—causes the port to remain in the unauthorized state, ignoring all attempts by
the client to authenticate. The switch cannot provide authentication services to the client through the
port.
Chapter 11
Configuring IEEE 802.1x Port-Based Authentication
Description
Enable the MAC authentication bypass feature.
Enable periodic re-authentication of the client.
Enable manual control of the authorization state of
the port.
Set the 802.1x timers.
Configure the violation modes that occur when a
new device connects to a port or when a new
device connects to a port after the maximum
number of devices are connected to that port.
Display 802.1x statistics, administrative status,
and operational status for the switch or for the
specified port. authentication manager:
compatibility with earlier 802.1x CLI commands
OL-21521-01
- Quick Links:
- Table of Contents
- Deployment Features
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
