Configuring Ipv6 Icmp Rate Limiting; Configuring Cef And Dcef For Ipv6 - Cisco Catalyst 3750-X Software Configuration Manual
Hide thumbs
Also See for Catalyst 3750-X:
- Command reference manual (1244 pages) ,
- Message manual (150 pages) ,
- Getting started manual (22 pages)
Table of Contents
Advertisement
Chapter 43
Configuring IPv6 Unicast Routing
Configuring IPv6 ICMP Rate Limiting
ICMP rate limiting is enabled by default with a default interval between error messages of 100
milliseconds and a bucket size (maximum number of tokens to be stored in a bucket) of 10.
Beginning in privileged EXEC mode, follow these steps to change the ICMP rate-limiting parameters:
Command
Step 1
configure terminal
ipv6 icmp error-interval interval [bucketsize]
Step 2
Step 3
end
show ipv6 interface [interface-id]
Step 4
Step 5
copy running-config startup-config
To return to the default configuration, use the no ipv6 icmp error-interval global configuration
command.
This example shows how to configure an IPv6 ICMP error message interval of 50 milliseconds and a
bucket size of 20 tokens.
Switch(config)#ipv6 icmp error-interval 50 20
Configuring CEF and dCEF for IPv6
Cisco Express Forwarding (CEF) is a Layer 3IP switching technology to improve network performance.
CEF implements an advanced IP look-up and forwarding algorithm to deliver maximum Layer 3
switching performance. It is less CPU-intensive than fast-switching route-caching, allowing more CPU
processing power to be dedicated to packet forwarding. In a Catalyst 3750-E switch stack, the hardware
uses distributed CEF (dCEF) in the stack. IPv4 CEF and dCEF are enabled by default. IPv6 CEF and
dCEF are disabled by default, but automatically enabled when you configure IPv6 routing.
To route IPv6 unicast packets, you must first globally configure forwarding of IPv6 unicast packets by
using the ipv6 unicast-routing global configuration command, and you must configure an IPv6 address
and IPv6 processing on an interface by using the ipv6 address interface configuration command.
To disable IPv6 CEF or distributed CEF, use the no ipv6 cef or no ipv6 cef distributed global
configuration command. To reenable IPv6 CEF or dCEF if it has been disabled, use the ipv6 cef or ipv6
cef distributed global configuration command. You can verify the IPv6 state by entering the show ipv6
cef privileged EXEC command.
For more information about configuring CEF and dCEF, see the "Implementing IPv6 Addressing and
Basic Connectivity" chapter in the Cisco IOS IPv6 Configuration Library on Cisco.com.
OL-21521-01
Purpose
Enter global configuration mode.
Configure the interval and bucket size for IPv6 ICMP error
messages:
interval—The interval (in milliseconds) between tokens
•
being added to the bucket. The range is from 0 to
2147483647 milliseconds.
bucketsize—(Optional) The maximum number of tokens
•
stored in the bucket. The range is from 1 to 200.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
Configuring IPv6
43-19
- Quick Links:
- Table of Contents
- Deployment Features
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
