Page 1
OWNER’S MANUAL LED TV * Disclaimer LG LED TV applies LCD screen with LED backlights. Please read this manual carefully before operating your set and retain it for future reference. LB58** www.lg.com *MFL68027132* P/NO : MFL68027132 (1403-REV02) Printed in Korea...
In addition to the source code, all referred license terms, warranty disclaimers and copyright notices are available for download. LG Electronics will also provide open source code to you on CD-ROM for a charge covering the cost of performing such distribution (such as the cost of media, shipping and handling) upon email request to opensource@lge.com.
SAFETY INSTRUCTIONS SAFETy INSTRUcTIONS Please read these safety precautions carefully before using the product. WARNING y Do not place the TV and/or remote y Make sure to connect Mains cable to control in the following environments: compliant AC mains socket with Grounded - A location exposed to direct sunlight earth pin.
Page 4
SAFETY INSTRUCTIONS y When mounting TV onto wall make sure to y Dispose of used batteries carefully to neatly install and isolate cabling from rear ensure that a small child does not consume of TV as to not create possibility of electric them.
Page 5
SAFETY INSTRUCTIONS y Do not allow any impact, shock or any y Unplug the TV from AC mains wall socket objects to fall into the unit, and do not drop if you do not intend to use the TV for a anything onto the screen.
Page 6
SAFETY INSTRUCTIONS y If you install the TV on a stand, you need y Do not place non-rechargeable batteries in to take actions to prevent the product from charging device. overturning. Otherwise, the product may fall over, which may cause injury. y Make sure there are no objects between the remote control and its sensor.
Page 7
SAFETY INSTRUCTIONS y Take care not to touch the ventilation y When cleaning the product and its openings when watching the TV for long components, unplug the power first periods as the ventilation openings may and wipe it with a soft cloth. Applying become hot.
Page 8
SAFETY INSTRUCTIONS y Contact the service centre once a year to y You may find different brightness and colour clean the internal parts of the product. of the panel depending on your viewing Accumulated dust can cause mechanical position(left/right/top/down). failure. This phenomenon occurs due to the characteristic of the panel.
ASSEMBLING AND PREPARING NOTE y Image shown may differ from your TV. y Your TV’s OSD (On Screen Display) may differ slightly from that shown in this manual. y The available menus and options may differ from the input source or product model that you are using.
Page 10
ASSEMBLING AND PREPARING ENERGY AV MODE INPUT SAVING FLASHBK LIST MARK MUTE Tag On MENU INFO Q.MENU ENTER BACK EXIT L/R SELECT FREEZE RATIO Remote control, Batteries Owner’s Manual Tag on (AAA) Cable Holder Cable Managements Power Cord Wall Mount Spacers Stand Screws Stand Screws 4EA, M4 x L20...
The model name or design may be changed depending on the upgrade of product functions, manufacturer’s circumstances or policies. AN-MR500 AN-VC5** LG Audio Device Magic remote Video call camera Tag on AN-WF500 Wi-Fi/Bluetooth Dongle * You can use the Magic Remote and LG Audio Device(Wireless) only when you are using the Wi-Fi/ Bluetooth Dongle.
ASSEMBLING AND PREPARING Parts and buttons Screen Speakers Joystick Button Remote control and Intelligent sensors Power Indicator 1 Intelligent sensor - Adjusts the image quality and brightness based on the surrounding environment. 2 Joystick Button - This button is located below the TV screen. NOTE y You can set the Power indicator Light to on or off by selecting OPTION in the main menus.
ASSEMBLING AND PREPARING Using the Joystick button You can simply operate the TV functions by pressing to turn On/Off or sliding your finger over joystick button moving up, down, left or right. Basic Functions When the TV is turned off, place your finger on the joystick Power On button and press it once and release it.
ASSEMBLING AND PREPARING Lifting and moving the TV y When transporting a large TV, there should be at least 2 people. Please note the following advice to prevent the y When transporting the TV by hand, hold the TV from being scratched or damaged and for TV as shown in the following illustration.
ASSEMBLING AND PREPARING Setting up the TV CAUTION Image shown may differ from your TV. y When attaching the stand to the TV Attaching the stand set, place the screen facing down on a cushioned table or flat surface to protect the screen from scratches.
Page 16
ASSEMBLING AND PREPARING Securing the TV to a wall WARNING (This feature is not available for all models.) y If a television is not positioned in a sufficiently stable location, it can be potentially hazardous due to falling. Many injuries, particularly to children, can be avoided by taking simple precautions such as: »...
200 x 200 400 x 400 We recommend the use of LG’s wall mount Standard screw M6 bracket. Number of When you do not use LG’s wall mount bracket, screws please use a wall mount bracket where the Wall mount LSW240B LSW440B...
Page 18
The wall mount bracket is not provided. Use an authorised LG wall mount and You can obtain additional accessories contact the local dealer or qualified from your local dealer.
MAKING CONNECTIONS MAKING cONNEcTIONS Antenna connection Connect the TV to a wall antenna socket with an RF cable (75 Ω). This section on MAKING cONNEcTIONS mainly uses diagrams for the 47LB580V models. Connect various external devices to the TV and switch input modes to select an external device.
MAKING CONNECTIONS Satellite dish connection Euro Scart connection (Only Satellite models) (Only Satellite models) Connect the TV to a satellite dish to a satellite Transmits the video and audio signals from an socket with a satellite RF cable (75 Ω). external device to the TV set.
MAKING CONNECTIONS Other connections Connect your TV to external devices. For the best picture and audio quality, Connect the external device and the TV with the HDMI cable as shown. Some separate cable is not provided. Headphone H/P OUT (Only Satellite models) 13/18V 700 mA Max...
Page 22
MAKING CONNECTIONS (Only Satellite models) PCMCIA card MHL passive cable Mobile phone HDMI AUDIO OUT DVI OUT DVD / Blu-Ray / HD Cable Box / HD STB / DVD / Blu-Ray / HD Cable Box / HD STB / PC (Only HDMI IN 1 (ARc) or HDMI IN 2) PC (Only HDMI IN 1 (ARc) or HDMI IN 2)
REMOTE CONTROL REMOTE cONTROL The descriptions in this manual are based on the buttons on the remote control. Please read this manual carefully and use the TV correctly. To replace batteries, open the battery cover, replace batteries (1.5 V AAA) matching the ends to the label inside the compartment, and close the battery cover.
USING THE USER GUIDE / MAINTENANCE USING THE USER GUIDE MAINTENANcE cleaning your TV User Guide allows you to more easily access the detailed TV information. Clean your TV regularly to keep the best performance and to extend the product lifespan. 1 Press the SMART button to access the Smart home menu.
TROUBLESHOOTING TROUBLESHOOTING Problem Solution Cannot control the y Check the remote control sensor on the product and try again. TV with the remote y Check if there is any obstacle between the product and the remote control. control. y Check if the batteries are still working and properly installed ( No image display y Check if the product is turned on.
ENVIRONMENTAL INFORMATION ENVIRONMENTAL INFORMATION (Only India) WEEE Disposal of your old appliance 1. When this crossed-out wheeled bin symbol is attached to a product it means the product is covered by the e-waste (Management and Handling) Rules, 2011. 2. All electrical and electronic products should be disposed of separately from the municipal waste stream via designated collection facilities appointed by the government or the local authorities.
SPECIFICATIONS SPEcIFIcATIONS Wireless LAN module(TWFM-B006D) specification Standard IEEE802.11a/b/g/n 2400 to 2483.5 MHz Frequency Range 5150 to 5250 MHz 5725 to 5850 MHz (for Non EU) 802.11a: 11 dBm 802.11b: 14 dBm Output Power (Max.) 802.11g: 10.5 dBm 802.11n - 2.4GHz: 11 dBm 802.11n - 5GHz: 12.5 dBm y Because band channel used by the country could be different, the user can not change or adjust the operating frequency and this product is set for the regional frequency table.
Page 28
SPECIFICATIONS Product specifications may be changed without prior notice due to upgrade of product functions. For the power supply and power consumption, refer to the label attached to the product. 32LB58** 39LB58** 42LB58** 32LB5800-TA 39LB5800-TA 42LB5800-TA 32LB580V-TA 39LB580V-TA 42LB580V-TA 32LB5820-TB 39LB5820-TB 42LB5820-TB 32LB582B-TB...
Page 29
SPECIFICATIONS 60LB58** 65LB58** 60LB5800-TA 65LB5800-TA 60LB580V-TA 65LB580V-TA 60LB5820-TB 65LB5820-TB 60LB582B-TB 65LB582B-TB 60LB582D-TB 65LB582D-TB MODELS 60LB582T-TB 65LB582T-TB 60LB582Y-TB 65LB582Y-TB 60LB582Z-TB 65LB582Z-TB 60LB5840-TA 65LB5840-TA 60LB584T-TA 65LB584T-TA 60LB589Y-TB 65LB589Y-TB 60LB589Z-TB 65LB589Z-TB 1373 x 848 x 280 1462 x 898 x 314 Dimensions With stand (mm) (W x H x D) Without stand(mm) 1373 x 801 x 58.8 1462 x 850 x 59.2...
Page 32
Record the model number and serial (Only DTV) number of the TV. Refer to the label on the back cover and quote this information to your dealer when requiring any service. MODEL SERIAL...
OWNER’S MANUAL EXTERNAL CONTROL DEVICE SETUP Please read this manual carefully before operating the set and retain it for future reference. www.lg.com...
KEY CODES KEY CODES • This feature is not available for all models. Code Code Function Note Function Note (Hexa) (Hexa) Q.Menu CH +, PR + R/C Button R/C Button CH -, PR - List, - (ATSC Only) R/C Button R/C Button Volume + List...
Page 35
(TV) (PC) • LGTV supports PL2303 chip-based (Vendor ID : 0x0557, Product ID : 0x2008) USB to serial converter RS-232C IN which is not made nor provided by LG. (CONTROL & SERVICE) (TV) (PC) • It can be purchased from computer stores that carry accessories for IT support professionals.
(TV) (PC) EXTERNAL CONTROL DEVICE SETUP (TV) (PC) RS-232C IN Phone jack Type (CONTROL & SERVICE) (PC) (TV) • You need to purchase the phone-jack to RS-232 cable required for the connection between the PC and RS-232C IN (CONTROL & SERVICE) (PC) (TV) the TV, which is specified in the manual.
EXTERNAL CONTROL DEVICE SETUP Communication Parameters • Baud rate : 9600 bps (UART) • Stop bit : 1 bit • Data length : 8 bits • Communication code : ASCII code • Parity : None • Use a crossed (reverse) cable. Command reference list (Depending on model) DATA...
EXTERNAL CONTROL DEVICE SETUP Transmission / Receiving Protocol Transmission [Command1][Command2][ ][Set ID][ ][Data][Cr] [Command 1] : First command to control the TV. (j, k, m or x) [Command 2] : Second command to control the TV. [Set ID] : You can adjust the [Set ID] to choose desired monitor ID number in option menu. Adjustment range in TV is 1 to 99.
Page 39
EXTERNAL CONTROL DEVICE SETUP * Commands may work differently depending on model and signal. 01. Power (Command: k a) 04. Volume Mute (Command: k e) ► To control Power *On or Off of the set. ► To control volume mute on/off. You can also adjust mute using the MUTE button Transmission[k][a][ ][Set ID][ ][Data][Cr] on remote control.
Page 40
EXTERNAL CONTROL DEVICE SETUP 09. Tint (Command: k j) 14. Color(Colour) Temperature (Command: x u) ► To adjust the screen tint. ► To adjust colour temperature. You can also adjust You can also adjust tint in the PICTURE menu. Color(Colour) Temperature in the PICTURE menu. Transmission [k][j][ ][Set ID][ ][Data][Cr] Transmission [x][u][ ][Set ID][ ][Data][Cr] Data Red : 00 to Green : 64...
Page 41
EXTERNAL CONTROL DEVICE SETUP * Digital Terrestrial/Cable/Satellite Data 05: Input Source (Analogue) - 00 : Terrestrial TV (ATV) [Data 00][Data 01]: Channel Data - 01 : Cable TV (CATV) Data 00 : High Channel data * Digital Terrestrial/Cable Data 01 : Low Channel data - 00 00 ~ 27 0F (Decimal: 0 ~ 9999) Data 00 : xx (Don't care) Data 02 : Input Source (Digital)
Page 42
EXTERNAL CONTROL DEVICE SETUP [Data 01][Data 02]: Major Channel Number 20. Control Back Light (Command: m g) Data 01: High byte Channel Data • For LCD TV / LED TV Data 02: Low byte Channel Data ► To control the back light. - 00 01 ~ 27 0F (Decimal: 1 ~ 9999) Transmission [m][g][ ][Set ID][ ][Data][Cr] [Data 03][Data 04]: Minor/Branch Channel Number...
Page 43
11 11 EXTERNAL CONTROL DEVICE SETUP 22. 3D(Command: x t) (only 3D models) [Data 01] It has own range for each 3D option (Depending on model) determined by [Data 00]. ► To change 3D mode for TV. 1) When [Data 00] is 00 Transmission [x][t][ ][Set ID][ ][Data 00][ ][Data 01] 00 : Right to Left 01 : Left to Right...