Table of Contents
Advertisement
Connecting the Uplink Ports
Step 7
Connect the SFP cables.
Figure 20: Port with SFP Transceiver Modules Installed
Removing SFP or SFP+ Transceiver Modules
For removing SFP or SFP+ modules from the modular port card, see the
Note
from the Modular Port Card, on page 68
Procedure
Step 1
Attach an ESD-preventive wrist strap to your wrist and to an earth ground surface.
Step 2
Disconnect the cable from the SFP transceiver module. For reattachment, note which cable connector plug is
send (Tx) and which is receive (Rx).
Step 3
Insert a dust plug into the optical ports of the SFP transceiver module to keep the optical interfaces clean.
Step 4
If the module has a bale-clasp latch, pull the bale out and down to eject the module. If you cannot use your
finger to open the latch, use a small, flat-blade screwdriver or other long, narrow instrument to open it.
Step 5
Grasp the SFP transceiver module, and carefully remove it from the slot.
Step 6
Place the SFP transceiver module in an antistatic bag or other protective environment.
Catalyst 6880-X Switch Hardware Installation Guide
50
section.
Installing the Switch
Removing SFP or SFP+ Modules
OL-30827-02
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
