hit counter script
Toro 1800 Power Curve Operator's Manual

Toro 1800 Power Curve Operator's Manual

Hide thumbs Also See for 1800 Power Curve:

Advertisement

1800 Power Curve
Model No. 38381—Serial No. 311000001 and Up
IMPORTANT SAFETY
INSTRUCTIONS
When using an electrical appliance, basic precautions should
always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE
USING THIS APPLIANCE
WARNING
—To reduce the risk of fire, electric shock,
or injury, follow these safety instructions.
It is essential that you or any other operator of the appliance
read and understand the contents of this manual before operating
the appliance. Pay particular attention to the safety alert symbol
which means CAUTION, WARNING, or DANGER—personal safety
instruction. Read and understand the instruction because it has to do
with safety. Failure to comply with these instructions may result in
personal injury, risk of fire, or electrical shock.
Replacement parts—When servicing the appliance, use only identical
replacement parts. The power cord and switch used on this machine
cannot be replaced. If the cord or switch become damaged, dispose
of the machine.
Do not use the appliance on graveled surface unless it is adjusted for
such a surface in accordance with the Operator's Manual.
Keep children and bystanders away—All visitors should be kept
at a distance from the work area.
Dress properly—Do not wear loose clothing or jewelry. They can
be caught in moving parts.
Wear rubber boots when operating the appliance.
Operating the appliance in the hand-held position is unsafe, except in
accordance with the special instructions for such use provided in the
Operator's Manual.
Warning—To prevent electric shock, use the appliance only with an
extension cord suitable for outdoor use.
Extension cords—To prevent the appliance cord and the extension
cord from disconnecting during operation, connect the extension cord
to the appliance as shown in Figure 9.
Avoid accidental starting—Do not carry the appliance with your
finger on the switch. Ensure that the switch is off when plugging in
the appliance.
If the appliance cord is damaged in any manner while it is plugged in,
disconnect the extension cord from the wall receptacle and contact an
Authorized Service Dealer.
Do not abuse the cord—Never carry the appliance by its cord or yank
on the extension cord to disconnect the appliance from the receptacle.
Keep the cord from heat, oil, and sharp edges.
Keep hands away from moving parts.
© 2011—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
Snowthrower
Keep guards in place and in working order.
Do not force the appliance—It will perform better and safer at the rate
for which it was designed.
Do not overreach—Watch your footing and keep your balance at all
times.
If the appliance strikes a foreign object, follow these steps:
Immediately release the control bar to stop the appliance.
Unplug the power cord.
Inspect for damage.
Repair any damage before starting and operating the appliance.
Disconnect the appliance—Disconnect the appliance from the power
supply when not in use, before servicing, when changing accessories,
etc.
Store an idle appliance indoors. When the appliance is not in use,
it should be stored indoors in a dry, secured place out of the reach
of children.
Maintain the appliance with care—Follow instructions for changing
accessories.
This appliance meets or exceeds the B71.3 specifications of the
American National Standards Institute in effect at the time of
production.
Read and understand the contents of this manual before you start
the motor.
This is the safety alert symbol. It is used to alert you to
potential personal injury hazards. Obey all safety messages that
follow this symbol to avoid possible injury or death.
Improperly using or maintaining this appliance could result in
injury or death. To reduce this potential, comply with the following
safety instructions.
This appliance is capable of amputating hands and feet and
of throwing objects. Failure to observe the following safety
instructions could result in serious injury.
Training
Read, understand, and follow all instructions on the appliance and
in the manual(s) before operating this appliance. Be thoroughly
familiar with all the controls and the proper use of the appliance.
Know how to stop the appliance and disengage the controls
quickly.
Never allow children to operate the appliance. Never allow adults
to operate the appliance without proper instruction.
Keep the area of operation clear of all persons, particularly small
children.
Exercise caution to avoid slipping or falling.
Preparation
Thoroughly inspect the area where the appliance is to be used
and remove all doormats, sleds, boards, wires, and other foreign
objects.
Register at www.Toro.com.
Meijer.com
Form No. 3365-267 Rev B
Operator's Manual
Original Instructions (EN)
Printed in the USA
All Rights Reserved

Advertisement

Table of Contents
loading

Summary of Contents for Toro 1800 Power Curve

  • Page 1: Important Safety Instructions

    Meijer.com Form No. 3365-267 Rev B ® 1800 Power Curve Snowthrower Model No. 38381—Serial No. 311000001 and Up Operator's Manual IMPORTANT SAFETY Keep guards in place and in working order. INSTRUCTIONS Do not force the appliance—It will perform better and safer at the rate for which it was designed.
  • Page 2: Safety And Instructional Decals

    Meijer.com • • Do not operate the appliance without wearing adequate winter Maintain or replace safety and instruction labels as needed. garments. Avoid loose fitting clothing that can get caught in moving • Run the appliance for a few minutes after throwing snow to prevent parts.
  • Page 3 Meijer.com 117-8778 1. To engage the rotor, press the interlock switch on the handle. 114-9034 117-8781 1. To disengage the rotor, release the interlock switch on the handle. 114-9035 1. Cutting/dismemberment hazard, rotor—do not place your hand in the chute; remove the ignition key and read the instructions before servicing or performing maintenance.
  • Page 4: Installing The Chute Control Rod

    Meijer.com Setup Installing the Chute Control Rod Position the discharge chute so that it faces forward. Note: Determine the left and right sides of the machine from the normal operating position. NOTICE! Align the arrow on the discharge chute with the arrow on the housing (Figure 3).
  • Page 5 Meijer.com Figure 7 Figure 5 1. Decal 2. Keyed hole Ensure that the handle of the chute control rod points upward (Figure 6), and insert the rod into the keyed hole in the back of the housing. Figure 6 1. Handle on the chute control rod Firmly push the rod into the keyed hole in the back of the housing until it snaps into place.
  • Page 6: Connecting To Power Source

    Meijer.com Operation Extension Cord Length Minimum Wire Gauge (A.W.G.) 100 feet Product Overview 150 feet Note: Do not use an extension cord over 150 feet. NOTICE! Check the extension cord frequently during use for holes or cracks in the insulation. Do not use a damaged cord. Do not run the cord through standing water or wet grass.
  • Page 7: Operating Tips

    Meijer.com WARNING A gap between the discharge chute and the chute deflector may allow the machine to throw snow and objects in the direction of the operator. Thrown objects could cause serious personal injury. • Do not force the chute deflector too far forward so that a gap appears between the discharge chute and chute deflector.
  • Page 8: Lubricating Machine

    Meijer.com Maintenance NOTICE! All electrical repairs should be performed by an Authorized Service Dealer only. Note: Determine the left and right sides of the machine from the normal operating position. WARNING If the extension cord is plugged into the machine, someone could accidentally operate the machine while you are performing maintenance on it, causing serious personal injury.
  • Page 9: Storage

    Service Toro has designed this machine to give you years of trouble-free use. Should it need service, bring the machine to an Authorized Toro Service Dealer, who is specially trained to repair Toro products and will ensure that your Toro stays “all” Toro.
  • Page 10 A Two-Year Full Warranty for Residential Use for the United States and Canada The Toro Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly warrant this product for two years against defects in material or workmanship when used for normal residential purposes.* If you think your Toro Product contains a defect in materials or workmanship, follow this procedure: •...
  • Page 11 Meijer.com Notes:...
  • Page 12 Meijer.com...

This manual is also suitable for:

38381 1800 power curve38381Power curve 1800

Table of Contents