Table of Contents
Advertisement
Wireless Security Page Description
Use the descriptions and instructions in the following table to configure the wireless
security for the residential gateway. After you make your selections, click Save
Settings to apply your changes or Cancel Changes to cancel.
Section
Field Description
Wireless
Wireless Security Mode
Security
Choose one of these options for the security mode:
WEP
Wired Equivalent Privacy (WEP) security mode is defined in the original IEEE 802.11 standard.
This mode is no longer recommended because of its weak security protection. Users are urged to
migrate to either WPA-Personal or WPA2-Personal.
Note: WPS mode does not support WEP on this device.
Field Descriptions
Encryption. Select a level of WEP encryption, 40 / 64 bits (10 hex digits) or 104 / 128 bits (26
hex digits).
Wireless Passphrase. To complete your wireless security setup, you should choose a wireless
passphrase that is easy for you to remember and hard for anyone else to guess. The first time
you connect a new wireless device to this network you may need to enter this passphrase into
the appropriate setup section in the connected device. To improve your network security, do
not give out this passphrase to unauthorized uses. Please enter a phrase of letters and/or
numbers from 4 to 24 digits long. Then, click Generate to create the Passphrase.
Key 1-4. If you want to manually enter WEP keys, then complete the fields provided. Each
WEP key can consist of the letters A through F and the numbers 0 through 9. It should be 10
characters in length for 40/64-bit encryption or 26 characters in length for 104/128-bit
encryption.
TX Key. Choose a Transmit (TX) Key from 1 to 4. The TX key is the key that will be used to
encrypt your data. Although four keys can be created, only one key is used for encrypting
data. Select one of the four keys for WEP encryption. Use the selected TX key to set up your
wireless clients.
4042592 Rev B
Configure Wireless Settings
43
Hide quick links:
Advertisement
Table of Contents
