Stacking The Switches - Cisco 500 Series Quick Start Manual
500 series stackable managed switches
Hide thumbs
Also See for 500 Series:
- Configuration manual (1140 pages) ,
- Administration manual (653 pages) ,
- User manual (60 pages)
Table of Contents
Advertisement
Available languages
Available languages
Make sure that any configuration changes are saved before
C
AUTION
exiting by issuing the command:
copy running-config startup-config
You are ready to configure the switch. Refer to the
Stackable Managed Switch Administration Guide
If you are not using DHCP on your network, set the IP address type
N
OTE
on the switch to Static and change the static IP address and subnet
mask to match your network topology. Failure to do so may result in
multiple switches using the same factory default IP address of
192.168.1.254.
Stacking the Switches
Before configuring the switches as a stack, refer to the Cisco 500 Series
Stackable Managed Switch Administration Guide for additional details.
Refer to the front panel graphics in
Series Stackable Managed Switch, page 16
descriptions and supported modules.
The following graphic shows the stack ports to assist in connecting the
devices in a stack:
LINK
ACT
XG
XG1
XG2
XG3
The 500X model is on the left, and the Sx500 model is on the right. The
SG500XG-8F8T model is shown below.
LINK
ACT
XG
9
10
10
Cisco Small Business
5G
XG4
/S1
/S2
Stack
11
12
for further information.
External Features of the Cisco 500
to help with the stack port
LINK/ACT GIGABIT
G25/S1
G26/S2
LINK
ACT
XG
13
14
500 Series Stackable Managed Switches
Cisco 500 Series
Cisco Small Business
LINK
ACT
LINK
ACT
SFP
G27/S3
G28/S4
1G/5G
LINK/ACT
15
16
GIGABIT
G1
Hide quick links:
Advertisement
Table of Contents
