Table of Contents
Advertisement
S
C
CANNER
ONFIGURATION TO THE
The IS4225 is shipped from the factory pre-configured to a set of default
parameters. It may be necessary to change the default parameters to match the
host system's requirements or to enable additional scanner functions. For a list
of possible parameter settings, refer to the Default Settings section of this guide.
To modify the scanner's default parameters follow the steps below using the
bar codes located in the MetroSelect Single-Line Configuration Guide
(
00-02544).
PN
1.
Scan the
ENTER CONFIGURATION MODE
The scanner will beep three times.
2.
Scan the bar code(s) for the desired parameter(s).
The scanner will beep once.
3.
Scan the
EXIT CONFIGURATION MODE
parameter settings. The scanner will beep three times.
If during the configuration process, there is a need to return the
scanner to the original factory settings, scan the recall defaults bar
code in the MetroSelect Configuration Guide. All settings selected
during that session or any previous sessions are discarded when you
scan the recall defaults code.
The IS4225 with RS232 interface can also be configured using MetroSet
is a PC-based utility software and available for download at
www.honeywellaidc.com. In addition, this interface can be configured using serial
configuration mode. For details, refer to the MetroSelect
Configuration Guide (PN 00-02544.)
H
S
OST
YSTEM
bar code to enter configuration mode.
bar code to exit and save the new
®
®
Single-Line
2 which
3
Hide quick links:
Advertisement
Table of Contents
