Supervisor Engine 2
Table 2-3
LED
ACTIVE
PWR MGMT
DISK
LINK
1. The SYSTEM and PWR MGMT LEDs on a redundant supervisor engine or RSP are synchronized to the active module.
Supervisor Engine 2
This section describes the Supervisor Engine 2 (see
features than the Supervisor Engine 720 and Supervisor Engine 32.
features on the front panel and
Note
In Cisco IOS Release 12.2SR and later releases, the Supervisor Engine 2 is no longer supported on
Cisco 7600 series routers.
Figure 2-6
CONSOLE port
WS-X6K-SUP2-2GE
SUPERVISOR2
Status
LEDs
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
2-14
RSP720, Sup720, and Sup32 LEDs (continued)
Color
Green
Orange
1
Green
Orange
Red
Green
Green
Orange
Flashing
orange
Off
Supervisor Engine 2 Front Panel
PCMCIA LED
CONSOLE
PORT
MODE
CONSOLE
CONSOLE PORT
PCMCIA slot
MODE switch
RESET button
Chapter 2
Description
The supervisor engine or RSP is operational and active.
The supervisor engine or RSP is powering up or is in standby mode.
Sufficient power is available for all modules installed in the router.
The supervisor engine or RSP is powering up or has minor hardware
problems.
Major hardware problem.
The disk is active. Do not remove the disk while the light is on or the file
may be corrupted.
The port is operational.
The port is disabled.
The port is bad.
The supervisor engine or RSP is powering up or the port is enabled and
there is no link.
Figure
Table 2-5
describes the LEDs.
Switch load
display
Switch
Load
100%
PCMCIA
EJECT
1%
Route Switch Processors and Supervisor Engines
2-6), which has slightly different controls and
Table 2-4
describes the controls and
1000BASE-X GBIC
Uplink Ports
PORT 1
PORT 2
LINK LEDs
OL-10100-04