Front Panel Description - Cisco CATALYST 6000 Installation And Configuration Note
Catalyst 6000 series content switching module
Hide thumbs
Also See for CATALYST 6000:
- Manual (52 pages) ,
- Product bulletin (4 pages) ,
- Installation note (18 pages)
Table of Contents
Advertisement
Overview
Table 1
Feature
Health Monitoring
Other Features
1. SSL = Secure Socket Layer
2. MTU = Maximum Transmission Unit
Front Panel Description
The CSM front panel features are shown in
Figure 1
Status
LED
The RJ-45 connector is covered by a removable plate.
Note
Status LED
When the CSM powers up, it initializes various hardware components and communicates with the
supervisor engine. The Status LED on the CSM shows the dialog with the supervisor engine and the
results of the initialization.
For more information on the supervisor engine LEDs, refer to the Catalyst 6000 Family Module
Note
Installation Guide.
During the normal initialization sequence, the status LED changes from Off to Red, Orange, and then
Green.
Catalyst 6000 Family Content Switching Module Installation and Configuration Note
4
Content Switching Module Features (continued)
Content Switching Module Front Panel
RJ-45 (Test)
connector
Table 2
describes the status LED operation.
Description
TCP, HTTP, ICMP, Telnet, FTP
SSL session ID, cookie and source IP address-based sticky
connections
Fragmented IP frames support
2
MTU
of 9000
Load and availability reporting supporting remote monitoring and
management
High availability preventing service disruptions
Redundant modules configured for fault-tolerance support
Figure
1.
CSG
78-11631-02 Rev. A0
Advertisement
Chapters
Table of Contents
