Replace The I/O Controller - Cisco 7200 VXR Quick Start Manual

Cisco 7200 vxr routers

Hide thumbs Also See for 7200 VXR:

User manual (178 pages)

Product overview (64 pages)

Manual (14 pages)

Table Of Contents

Table of Contents

Note

If you have difficulty installing a processing engine or I/O controller in the lowest slot of a Cisco 7200 VXR

router that is rack-mounted, remove the port adapters, processing engine and I/O controller from the chassis

and reinstall them. Install the processing engine and I/O controller in the lowest slots first, then populate the

slots above them, in a bottom-to-top order.

Step 5

Grasp the handle and pull the NPE or NSE from the chassis.

Step 6

Insert the NPE or NSE and tighten the captive installation screws.

Step 7

If you are replacing an NPE-G1, install the cable-management brackets and cables. See Figure 6 and Figure 9.

Step 8

Connect the router to the power source and power up the router.

See the Network Processing Engine or Network Services Engine Installation and Configuration publication at

http://www.cisco.com/en/US/products/hw/routers/ps341/products_installation_guide_book09186a0080551c34.html.