Cisco 7200 VXR Quick Start Manual page 35

Cisco 7200 vxr routers

Hide thumbs Also See for 7200 VXR:

Table of Contents

Check the Running Configuration Settings

To check the value of the settings you have entered, enter the show running-config command at the

prompt:

Router#

Router# show running-config

To review changes you make to the configuration, use the EXEC mode show startup-config command to display the information

stored in NVRAM.

View Your System Configuration

You can use the show version (or show hardware) and the show diag commands to display the system hardware (the network

processing engine or network services engine and the number of interfaces installed), the software version, the names and

sources of configuration files, and the boot images. Use the show diag command to determine what type of port adapters and

I/O controller are installed.

For specific information on the show version, show diag, and other commands, refer to the modular configuration and modular

command reference publications in the Cisco IOS software configuration documentation set that corresponds to the software

release installed on your Cisco hardware.

Perform Complex Configurations

After you have installed your Cisco 7200 VXR router hardware and minimally configured the system, you might need to

perform more complex configurations, which are beyond the scope of this publication.

For specific information on system and interface configuration, refer to the modular configuration and modular command

reference publications in the Cisco IOS software configuration documentation set that corresponds to the software release

installed on your Cisco hardware. These publications contain additional information on using the configure command.

Replace or Recover a Lost Password

See the Cisco 7200 VXR Installation and Configuration Guide, Chapter 4, "Observing System Startup and Performing a Basic

Configuration" for instructions. It is possible to recover the enable or console login password. The enable secret password is

encrypted and must be replaced with a new enable secret password.

Table of Contents