Rack-Mount The Router - Cisco 7200 VXR Quick Start Manual

Cisco 7200 vxr routers

Hide thumbs Also See for 7200 VXR:

Table of Contents

Rack-Mount the Router

Figure 4

Attaching the Rack-Mount Brackets to the Front of the Chassis

Cisco 7200

Series

Rack-mount bracket

Cable-management bracket

Brackets Front-Mounted—Chassis Protrudes from the Rack

Locate the rack-mount and cable-management brackets and screws and a Number 2 Phillips screwdriver.

Step 1

Align the rack-mount bracket (1)—as shown above—to the side of the router. Insert and tighten the screws (3) if you

are not adding the cable-management brackets. Repeat this step on the other side of the router.

Go to the "Two-Post or Four-Post Rack Installation" section on page 16.

Step 2

If you are using the cable-management brackets, align the rack-mount bracket (1) to the side of the router, align the

cable-management bracket (2) over the rack-mount bracket—as shown above—and insert the screws (3) through both.

Tighten the screws. Repeat this step on the other side of the router.

If you have an NPE-G1 or NPE-G2 installed, go to the "NPE-G1 and NPE-G2 Rear Cable-Management Brackets on a

Front-Mounted Router" section on page 12.

If you do not have an NPE-G1 or NPE-G2 installed, go to the "Two-Post or Four-Post Rack Installation" section on page 16.

ETHERNET 10BT

TOKEN RING

ETHERNET-10BFL

FAST ETHERNET INPUT/OUTPUT CONTROLLER

M4 x 8-mm Phillips flathead screws

Table of Contents