48-Port 10/100Base-T Ethernet Switching Module (Ws-X6148-Rj21V) - Cisco 7600 Series Module Manual
Hide thumbs
Also See for 7600 Series:
- Hardware installation manual (144 pages) ,
- Hardware manual (122 pages) ,
- Manual (70 pages)
Table of Contents
Advertisement
Chapter 2
Ethernet and Gigabit Ethernet Switching Modules
•
•
The QoS port architecture (Rx/Tx) for this module is 1q4t/2q2t.
Figure 2-3
The front panel LEDs are described in
48-Port 10/100BASE-T Ethernet Switching Module (WS-X6148-RJ21V)
The 48-port 10/100BASE-T switching module (WS-X6148-RJ21V) provides 48 switched, 10/100-Mbps
autosensing, full- or half-duplex ports. (See
per connector) for use with either Category 3, Category 5, Category 5e, or Category 6 UTP cable. The
"V" in the product number indicates that the inline-power daughter card (WS-F6K-VPWR) is installed
on the module. With the WS-F6K-VPWR daughter card installed, the module provides these IP phone
features on each port:
•
•
•
The QoS port architecture (Rx/Tx) for this module is 1q4t/2q2t.
Figure 2-4
The front panel LEDs are described in
OL-9392-05
Phone discovery—Automatically detects the presence of an IP phone and supplies inline power to
the phone.
Auxiliary VLANs—Provides automatic VLAN configuration for IP phones using IEEE 802.1Q as
the standards-based VLAN tagging mechanism between the switch and the IP phone.
48-Port 10/100/1000BASE-T Ethernet Switching Module (WS-X6148V-GE-TX)
WS-X6148V-GE-TX
1
11
2
12
STATUS
Inline power—Provides 48 VDC over standard Category 5, Category 5e, or Category 6 UTP cable
up to 328 feet (100 meters) from the switch to the IP phone. With inline power, pairs 2 and 3 (pins
1, 2, 3, and 6) of the four pairs in the cable are used to transmit power (6.3 W) from the switch. This
method of supplying power is sometimes called phantom power because the power signals travel
over the same two pairs used to transmit Ethernet signals. The power signals are completely
transparent to the Ethernet signals and do not interfere with their operation.
Phone discovery—Automatically detects the presence of an IP phone and supplies inline power to
the phone.
Auxiliary VLANs—Provides automatic VLAN configuration for IP phones using IEEE 802.1Q as
the standards-based VLAN tagging mechanism between the switch and the IP phone.
48-Port 10/100BASE-T Ethernet Switching Module (WS-X6148-RJ21V)
WS-X6348-RJ21
STATUS
13
23
25
14
24
26
48 PORT
10/100/1000
BASE-T GE
Table 2-3 on page
2-35.
Figure
2-4.) The module has 4 RJ-21 connectors (12 ports
48 PORT
10/100 BASE-T
ETHERNET
Table 2-3 on page
2-35.
10/100 and 10/100/1000 Ethernet Switching Modules
35
37
36
38
SWITCHING MODULE
SWITCHING MODULE
Cisco 7600 Series Router Module Guide
47
48
PHONE
PHONE
2-19
Advertisement
Table of Contents
