Cisco Catalyst 3750-X Command Reference Manual page 529

Cisco ios release 15.2(1)e and later

Hide thumbs Also See for Catalyst 3750-X:

Table of Contents

Catalyst 3750-X and 3560-X Switch Cisco IOS Commands

Naming conflicts can occur when multiple data-stacked switches are connected to the same XPS. To

avoid conflicts, configure the name only for the lowest switch number in the stack that is connected to

the XPS. The show commands display only the name configured for the lowest switch number in the

stack that is connected to the XPS. Other configured names are stored in the config.text file, but are

ignored in the show command outputs.

You can verify your settings by entering the show env xps configuration or show env xps port

privileged EXEC command.

This example shows how to configure the name of the XPS 2200 that is connected to a Catalyst 3750-X

switch stack in a stack as a accounting:

Switch> power xps 2 name accounting

This example shows how to configure the name of an XPS 2200 that is connected to a Catalyst 3560-X

switch as the serial number of the XPS:

Switch> power xps name serialnumber

This example shows how to configure the name of XPS port 1 as switcha:

Switch> power xps port 1 switcha

Related Commands

power xps (privileged

EXEC command)

show env xps [system] Displays the status of the XPS connected to a switch or switch stack,

Configures XPS ports and power supplies.

including the names of the ports and XPS.

Catalyst 3750-X and 3560-X Switch Command Reference

power xps (global configuration)

Catalyst 3560-x