Table of Contents
Advertisement
Selecting Layers
Input Channels and Output Channels (Bus Outs & Aux Outs) are arranged into layers, as
illustrated below. There are four layers altogether.
The currently-selected layer determines the function of
the channel strip, [SEL] buttons, [SOLO] buttons,
[ON] buttons, and faders. Use the LAYER buttons to
select a layer you wish to edit using the channel strip
controls.
The following table shows the layers that you can access using the LAYER buttons, and the
parameters you can control using the channel strips on each layer.
LAYER buttons
[1–16] button
[17–32] button
[REMOTE] button
[MASTER] button
Tip:
• The function of each channel strip fader depends on the currently-selected Fader mode (see
page 33).
• The STEREO [SEL] button, [ON] button, and [STEREO] fader always control the Stereo
Out signal, regardless of the Layer settings.
• The ST IN [SEL] buttons, [SOLO] buttons, [ON] buttons, and level control knobs always
adjust the ST IN channels selected via the [ST IN] button regardless of the Layer settings.
Input Channel Layer 1–16
Input Channel Layer 17–32
Master Layer
Remote Layer
Layers
Input Channel Layer 1–16
Input Channel Layer 17–32
Remote Layer
Master Layer
Selecting Layers
LAYER
1-16
17-32
MASTER REMOTE
Channel Strips
1–8
9–16
Input Channels 1–16
Input Channels 17–32
Operation depends on the selected
target (see page 189).
Aux Send masters
Bus Out masters
1–8
1–8
01V96 Version 2—Owner's Manual
31
3
Advertisement
Table of Contents
