hit counter script
Zanussi PN 64 Instruction Booklet
Zanussi PN 64 Instruction Booklet

Zanussi PN 64 Instruction Booklet

Gas hob pn 64; ps 64; pw 64; px 64; ptdf 64

Advertisement

GAS HOB
MODELS
PN 64
PS 64
PW 64
PX 64
PTDF 64
INSTRUCTION BOOKLET
IL
35673-2502

Advertisement

Table of Contents
loading

Summary of Contents for Zanussi PN 64

  • Page 1 GAS HOB MODELS PN 64 PS 64 PW 64 PX 64 PTDF 64 INSTRUCTION BOOKLET 35673-2502...
  • Page 3: Table Of Contents

    Important Safety Information You MUST read these warnings carefully before installing or using the appliance. Installation Do not use this appliance if it is in contact with water. Do not operate the appliance with wet hands. This appliance must be installed by qualified Ensure the control knobs are in the ‘OFF’...
  • Page 4: Description Of The Hob

    Description of the Hob 1. Hob Top 2. Auxiliary Burner 3. Semi-rapid Burners 4. Powered Rapid Burner 5. Control knob for front left burner (auxiliary) 6. Control knob for back left burner (semi-rapid) 7. Control knob for back right burner (semi-rapid) 8.
  • Page 5: Operation

    Operation This hob is provided with a safety device, which If you use a saucepan which is smaller than the will stop the gas flow if the flame accidentally goes recommended size, the flame will spread beyond off during cooking. the bottom of the vessel, causing the handle to overheat.
  • Page 6: Maintenance And Cleaning

    Maintenance and Cleaning Before any maintenance or cleaning can be carried out, you must DISCONNECT the hob from the electricity supply. The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool. The Hob Top Regularly wipe over the hob top using a soft cloth well wrung out in warm water to which a little washing up...
  • Page 7: Something Not Working

    Something Not Working? If the appliance is not working correctly, please carry out the following checks before contacting your local Service Centre. SYMPTOM SOLUTION There is no spark when lighting the gas Check that the unit is plugged in and the electrical supply is switched on.
  • Page 8: Installation

    Installation FO 1010 IMPORTANT This appliance must be installed by qualified personnel. The manufacturer will not accept liability, should the above instructions or any of the other safety instructions incorporated in this book be ignored. A) End of shaft with nut Gas Connection B) Washer C) Adjustable joint...
  • Page 9: Fitting The Hob To The Worktop

    Building over a kitchen unit with oven 550 min. If the hob is built into a kitchen unit with an oven underneath, the recess must have the dimensions shown in diagrams 2 and 3, and should also incorporate suitable oven crosspiece supports to ensure an efficient cooling air circulation.
  • Page 10: Electrical Connections

    Electrical connections Permanent Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or In the case of a permanent connection, it is necessary competent person, in accordance with the current that you install a double pole switch between the regulations.
  • Page 11: Commissioning

    Commissioning When the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedure below. Turn the gas tap to the MAX position and ignite. Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX several times.

This manual is also suitable for:

Ptdf 64

Table of Contents