WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings.
Page 3
Installation During normal operation, the condenser and compressor at the back of the appliance heat up considerably. For safety reasons, minimum ventilation must be as shown in the relevant Figure. Attention: keep ventilation openings clear of obstruction. If the appliance is transported horizontally, it is possible that the oil contained in the compressor flows in the refrigerant circuit.
CONTENTS Installation Customer service Location What to do if the appliance is not functioning properly. Rear spacers Cleaning the interior Door reversibility Technical specification Electrical connection Operation Control panel Operation - Temperature adjustment / O knob Storage of foods in refrigerator compartment Movable wire shelves Use and features of the «CRISP’N FRESH»...
INSTALLATION If this appliance featuring magnetic door seals is to replace an older appliance having a spring lock (latch) on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child.
Important It is essential that the appliance be connected to an efficient earth tap. For this purpose the supply cable plug incorporates a special earth contact. If the sockets of your domestic wiring system are not earthed, have the appliance connected to a separate earth wire by a qualified electrician in accordance with existing safety regulations.
Door reversibility Fig. 3 Unplug the appliance from the power supply before carrying out the below-mentioned operations. Remove the ventilation grill (D). Unscrew the bottom hinge (E). Remove the freezer door by releasing it from the middle hinge (H). Unscrew the middle hinge. D640 Remove the fridge door by releasing it from the top hinge pin (A).
TECHNICAL SPECIFICATION The technical data is indicated in the rating plate on the left side inside the appliance. Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by 6% of the rated voltage.
OPERATION Control panel A. / O pilot light C. Thermostat knob B. / O knob D. Operating pilot light Operation - Temperature knob adjustment For correct operation, even at low ambient temperatures, the appliance is fitted with a special After cleaning the appliance’s interior, connect the knob with control located on the control panel.
Movable wire shelves Fig. 4 The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. Use and features of the «CRISP’N D351 FRESH» filter Fig. 5 The glass shelf on top of the vegetable drawer is fitted with a special filter called «CRISP’N FRESH»...
Positioning the door shelves Fig. 7 To permit storage of food packages of various sizes, the door shelves can be adjusted in height. To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required.
prepare food in small portions to enable it to be rapidly and completely frozen and to make it possible Important subsequently to thaw only the quantity required; If there is a power failure when food is in the wrap up the food in aluminium foil or polythene and freezer, do not open the door of the freezer make sure that the packages are airtight;...
Defrosting Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container on the back of the appliance where it evaporates.
MAINTENANCE Periods of non-operation Unplug the appliance before carrying out any maintenance operation. When the appliance is not in use for long periods, disconnect from the mains, empty and clean, leaving Warning the door ajar to prevent unpleasant smells. This appliance contains hydrocarbons in its cooling unit;...