Adjusting The Rear Brake Light Switch - Yamaha Drag Star XVS650 Owner's Manual
Drag star 2001
Hide thumbs
Also See for Drag Star XVS650:
- Service manual (360 pages) ,
- Owner's manual (101 pages) ,
- Supplementary service manual (47 pages)
Table of Contents
Advertisement
1. Locknut
2. Brake pedal position adjusting bolt
1. Loosen the locknut at the brake
pedal.
2. To raise the brake pedal, turn the
adjusting bolt in direction a. To
lower the brake pedal, turn the ad-
justing bolt in direction b.
3. Tighten the locknut.
WARNING
_
After adjusting the brake pedal posi-
tion, the brake pedal free play must
be adjusted.
_
PERIODIC MAINTENANCE AND MINOR REPAIR
1. Brake pedal free play adjusting nut
Brake pedal free play
The brake pedal free play should mea-
sure 20–30 mm at the brake pedal end.
Periodically check the brake pedal free
play and, if necessary, adjust it as fol-
lows.
To increase the brake pedal free play,
turn the adjusting nut at the brake rod
EWA00044
in direction a. To decrease the brake
pedal free play, turn the adjusting nut in
direction b.
1. Rear brake light switch
2. Rear brake light switch adjusting nut
Adjusting the rear brake light
switch
The rear brake light switch, which is ac-
tivated by the brake pedal, is properly
adjusted when the brake light comes
on just before braking takes effect. If
necessary, adjust the brake light switch
as follows.
Turn the adjusting nut while holding the
rear brake light switch in place. To
make the brake light come on earlier,
turn the adjusting nut in direction a. To
make the brake light come on later,
turn the adjusting nut in direction b.
6-22
EAU00713
6
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
