IntroductIon data plate Thank you for choosing the Electrolux Wine Cellar. Check the data plate, inside the wine cellar at the top left, to ensure you have received the right Please read the following instructions carefully be- model. fore installing your new wine cellar. We trust you will be completely satisfied with your purchase.
WARNING the wine cellar must be earthed. The wine cellar is fitted with a plug intended for an earthed socket. Electrolux and its subsidiaries will For optimum performance, please place not be held responsible for any incident due to non- your wine cellar far away from any source existent or defective earth wires.
Each kit contains two shelves and shelf supports. Sliding shelf kit number: 921 17 81-99 Storage shelf kit number: 921 17 81-98 Model Max. no. of sliding shelves CS 110 8 (wooden door) / 9 (glass door) CS 160 CS 200 - 5 -...
Page 6
No. of No. of Model storage shelves bottles CS 110 CS 160 CS 200 Place bottles top to bottom in the cellar for op- timum volume use. The sliding shelves and the storage shelves can be placed in several positions depending on the size of your wine cellar.
appendIx a - InstructIon for mountIng the handle staInless steel doors Remove the door gasket behind the two holes adapted for the handle. Start in the upper corner and gently pull out the gasket from the slot. Continue down and pass the two holes. From the inside of the door, put the two attached screws (M4x60) first screw...