Important Safety Instructions These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. Your safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department. Prior to Installation General Safety •...
Servicing • This product should be serviced by an authorised engineer and only genuine spare parts should be used. • Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning.
Operation Before use Remove all securing tapes. Wash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or detergent as the smell may linger. Dry thoroughly. Freezer controls ➂...
compartment. To remove the drawers, proceed as follows: pull the drawer out until it comes to a stop, then tilt it upwards You should never freeze more than 16 Kg. of (see figure). fresh food at anyone time. Once the food is completely frozen (which could take up to 24 hours) the fast freeze function can be ended ➃...
Normal Operating Sounds You may hear faint gurgling or bubbling sounds when the refrigerant is pumped through the coils or tubing at the rear, to the fixed freezer shelves. When the compressor is on, the refrigerant is being pumped round, and you will hear a whirring sound or pulsating noise from the compressor.
Defrosting The freezer compartment will become progressively Important covered with frost. This should be removed with the A temperature rise of the frozen food packs special plastic scraper provided, whenever the during defrosting may shorten their storage thickness of the frost exceeds 1/4". life.
Maintenance and Cleaning Internal cleaning Warning Before any maintenance or cleaning work Clean the inside and accessories with warm water is carried out, DISCONNECT the appliance and bicarbonate of soda (5ml to 0.5 litre of water). from the ELECTRICITY supply. Rinse and dry thoroughly.
Something not Working? Before contacting your local Service Force Centre check the following points. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Symptom Solution No power to appliance...
Service and Spare Parts In the event of your appliance requiring service, or if When you contact the Service Force Centre you will you wish to purchase spare parts, please contact need to give the following details: your local Service Force Centre by telephoning:- 1.
Guarantee Conditions Standard guarantee conditions We, Electrolux, undertake that if within 12 months of the date of purchase this Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: •...
Technical specifications POWER SUPPLY VOLTAGE AND FREQUENCY 230-240 V / 50 Hz RATED CURRENT 0, 7 A AVERAGE DAILY UNITS ELECTRICITY(*) 0,57 kWh GROSS CAPACITY 110 l NET CAPACITY 94 l STAR RATING (*)This figure is based on standard test results in accordance with European Standard EN153 (Actual consumption will depend on how the appliance is used and where it is located).
Electrical Connection If you fit your own plug, the colours of the wires in the WARNING mains lead of your appliance, may not correspond THIS APPLIANCE MUST BE EARTHED. with the markings identifying the terminals in your The manufacturer declines any liability plug, proceed as follows: should this safety measure not be Connect the Green and the Yellow (earth) wire to the...
Building in Dimensions of the recess Height of housing mm 880 Depth of housing mm 550 Width of housing mm 560 1. Fit the appliance in the niche by making sure that it stands against the interior surface of the unit on the side where the door hinges of the appliances are fitted.
Page 16
7. Fix cover (Hc) on guide (Ha) until it clips into place. 4. Snap vent grill (B) and hinge cover (E) into position. Apply blanking covers (C-D) as indicated. 8. Open the appliance door and the furniture door at 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture 5.
Page 17
10. Place the small square on the guide again and fix it with the screws supplied. Should the alignment of the furniture door be necessary, use the clearance of slots. At the end of this procedure, it is necessary to check if the door of the furniture closes properly.