Service center authorized professionals. General safety This appliance must be installed in a room separate Make sure that gas type used id identical to the type from living rooms and have a good ventilation. specified on the nameplate. www.zanussi.com...
Page 3
The heater must be installed onto a vertical wall in a correct vertical way. Usage This appliance is designed for domestic use. It must not be used for purposes other than those for which it was designed www.zanussi.com...
Water Control knob - Operates only when appliance in use, it displays - Used to control water flow rate, on (Min) position outlet water temperature. it decreases the water flow to the minimum level and start up pressure to the minimum, www.zanussi.com...
Keep the heater away The space of exhaust pipes from ceiling should be from heat sources such as gas cockers. The appliance must vertical on mounting. not less than 60cm and from side walls not less than 30cm. www.zanussi.com...
- Exhaust pipe must be able to with stand self - Switch valves should be installed on gas and weight, wind ,accumulated snow and shake. water supply pipes to make it convenient for Caution! Don't mount exhaust pipe on a installation or repair. windward location. www.zanussi.com...
Temporary shutdown - When hot water temporary not needed during use, just turn off the hot water valve. when hot water needed again, turn on the hot water valve again. www.zanussi.com...
Check water supply main pressure Safety feature activated(20 minutes of use shut-off timer) o Re-start the appliance (close outlet water valve and re-open) Low battery o Replace batteries Strong wing outside o Wait until wind stop www.zanussi.com...
Max water flow (2bar) 10 L/min Exhaust discharge type Flue type Gas inlet 1/2 inch Connections Water inlet 1/2 inch Water outlet 1/2 inch Dimension (Height "A"*Width "B"*Depth "C") 570*330*190 mm Chimney diameter Ø 110 mm Nozzle diameter Ø 0.78 mm www.zanussi.com...