Table of Contents
Advertisement
Chapter 2
Configuring T1/E1 Interfaces
Router(config-if)# encapsulation hdlc
!
! Exit interface configuration mode
!
Router(config-if)# exit
!
! Exit global configuration mode
!
Router(config)# exit
CEM Configuration Example
The following example shows how to add a T1 interface to a CEM group as a part of a SAToP pseudowire
configuration. For more information about how to configure pseudowires, see
Pseudowire."
Note
This section displays a partial configuration intended to demonstrate a specific feature.
controller T1 0/1
framing unframed
clock source internal
linecode b8zs
cablelength short 110
cem-group 0 unframed
interface CEM0/1
no ip address
cem 0
xconnect 192.0.2.1 1000 encapsulation mpls
OL-27620-01
Cisco ME-3600X-24CX Series Switch Chassis Configuration Guide
Configuration Examples
Chapter 5, "Configuring
2-17
Advertisement
Table of Contents
