Table of Contents
Advertisement
Chapter 4
Mounting the Router
Materials and Tools You Supply
You must supply some or all of these items to mount the router on a pole. The items you supply depend
on the installation procedure that you use.
Item
#2 Phillips screwdriver
Crimping tool or pliers
Router Orientation When Mounting
When mounting the router on a DIN rail or wall, ensure that the router is oriented with the chassis
cabling openings pointing down so the router cable hangs down.
Caution
Mounting the router with the cable panel at the top (facing up) can cause stress on the cables and
potentially impact network and other connections. Cisco discourages mounting the router with the cable
panel at the top.
General Safety Information for Mounting
Before performing any of the tasks in this chapter, read the safety warnings in this section and in the
Installation Safety and Site Preparation
One person is required to properly and safely mount the router.
Caution
All mounting methods at any location are subject to the acceptance of local jurisdiction.
Personnel mounting the router must understand grounding methods.
Caution
Warning
Do not locate the antenna near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, as they may cause serious injury or death. For proper
installation and grounding of the antenna, please refer to national and local codes (for example,
U.S.:NFPA 70, National Electrical Code, Article 810, Canada: Canadian Electrical Code, Section 54).
Statement 1052
OL-26438-02
Required for These Procedures
Attach the Mounting Bracket to the Router
Ground the Router
Ground the Router
chapter.
Cisco 1120 Connected Grid Router Hardware Installation Guide
Prepare to Mount the Router
4-3
Hide quick links:
Advertisement
Table of Contents
