Table of Contents
Advertisement
Mounting Instructions
Figure 4-4
1
Mount the Router on a DIN Rail
The steps in this section assume that your substation or utility box already has a DIN rail installed and
ready to support equipment. If your environment does not use DIN rails, you can
a Wall, page
To mount the router on a DIN rail:
Step 1
Tilt the chassis-bracket assembly about 10 to 30 degrees and the bracket handle facing down. Do not
mount the router with the bracket handle facing up.
Step 2
Place the top lip of the bracket (Item 2 in
Figure
Step 3
Firmly pull the bracket handle (Item 1 in
wall or DIN rail.
Use caution when pulling the bracket handle: The handle is spring-loaded and will snap shut when
Caution
released quickly.
Slowly release the bracket handle so that the bottom lip of bracket is secured over the top of the DIN rail.
Step 4
Cisco 1120 Connected Grid Router Hardware Installation Guide
4-6
Replace and Tighten Screws to Secure Bracket to Router
4-7.
4-5).
Figure
4-5) over the top of the DIN rail (Item 3 in
Figure
4-5) down and rotate the unit until it is parallel to the
Chapter 4
Mounting the Router
Mount the Router on
OL-26438-02
Hide quick links:
Advertisement
Table of Contents
