Advertisement
Part No. 3186508 Rev. A
A WARNING
l
ALL RANGES CAN
TIP
l
INJURY TO PERSONS
COULD RESULT
l
INSTALL ANTI-TIP
DEVICE PACKED
WITH RANGE
l
SEE INSTALLATION
INSTRUCTIONS
IMPORTANT:
Read and save
these instructions.
IMPORTANT:
Installer:
Leave installation
Instructions
with the homeowner.
Homeowner:
Keep Installation
Instructions
for future reference.
Save
Installation
Instructions for local
electrical inspector's use.
/Electric
Thermal/Convect
ion
Slide-in Range
with self-cleaning
oven
Advertisement
Table of Contents
Related Manuals for KitchenAid 3186508
Summary of Contents for KitchenAid 3186508
- Page 1 Part No. 3186508 Rev. A A WARNING ALL RANGES CAN INJURY TO PERSONS COULD RESULT INSTALL ANTI-TIP DEVICE PACKED WITH RANGE SEE INSTALLATION INSTRUCTIONS IMPORTANT: Read and save /Electric these instructions. Thermal/Convect IMPORTANT: Slide-in Range Installer: Leave installation Instructions with the homeowner.
-
Page 2: Product Dimensions
Cabinet opening dimensions Before you start... Read electrical, gas and carpentry instructions. Fdr minimum clearance to the top of the cooktop, see Note.“” Proper installation is your responsibility. qualified technician should install this range. Make sure you have everything necessary for correct installation. -
Page 3: Tools And Materials Needed For Installation
If this information does not agree with the type of gas available, check with your KitchenAid dealer. Conversion to L.P. gas requires Kit No. 4175461, available from your KitchenAid Dealer. This conversion must be done by a qualified technician. -
Page 4: Electrical Connection
Electrical Now start... connection With range in kitchen. Remove cooktop burner grates and caps package from shipping box. Remove hardware package from side of oven. Electrical Shock Hazard Electrical ground is required on this appliance. Do Not connect to the electrical supply sp!cer until appliance is permanently Remove shipping materials, tape and... - Page 5 L.P. gas to seal all gas connections. Make from your new dual fuel range, read sure flexible connector is not kinked. Seal all your KitchenAid Use and Care Guide. openings in floor or wall where range is Keep Installation instructions installed.
- Page 6 Check that gas valves are set to the “ON” position. Repeat Step 16. If a burner does not light at this point, contact a KitchenAid dealer for assistance. (181 Refer to your “Use and Care Guide”...
-
Page 7: Home Appliances
Replace screws and secure If you need range to cabinet. Reconnect the electric supply. service... In the event that your KitchenAid appliance Personal Injury/Product Damage Hazard should need service, call the dealer from whom Do Not step, lean or sit on the range you purchased the appliance or a KitchenAid- door.