Dhcp_Snooping-4 - Cisco Catalyst 4500 Series System Message Manual
Cisco ios system message guide ios release 12.2(37)sg
Hide thumbs
Also See for Catalyst 4500 Series:
- Software configuration manual (2086 pages) ,
- Administration manual (1814 pages) ,
- Configuration manual (1610 pages)
Table of Contents
Advertisement
Chapter 2
Messages and Recovery Procedures
DHCP_SNOOPING-4
Error Message DHCP_SNOOPING-4-AGENT_OPERATION_FAILED_N: DHCP snooping binding
transfer failed ([dec]). [chars]
Error Message DHCP_SNOOPING-4-AGENT_OPERATION_FAILED: DHCP snooping binding
transfer failed. Unable to access URL.
OL-13091-01
This message is logged once every 30 minutes and displays the [dec] number of failures
Explanation
that occurred for a given reason [chars] during the past 30 minutes.
This message is a rate-limited version of the
Based on the reason for the error [chars], look at the explanation for the
Recommended Action
DHCP_SNOOPING-4-AGENT_OPERATION_FAILED message, and take the appropriate action.
The DHCP snooping binding transfer failed. The reason for failure can include any of
Explanation
the following:
–
The URL is not available to use.
Not enough memory is available for creating an agent.
–
–
The number of agents reached the maximum supported limit.
The switch is unable to create an agent.
–
The switch is unable to access the URL.
–
The switch is unable to start the agent.
–
The Abort timer expired.
–
The number of entries exceeded the maximum supported limit.
–
An error occurred when reading the remote database.
–
–
An error occurred while writing to the remote database.
–
DHCP snooping expected more data during the read.
The string type is invalid.
–
The version string type is invalid.
–
DHCP snooping is expecting a new line in the database.
–
'TYPE' was not found in the remote database.
–
'VERSION' was not found in the remote database.
–
'BEGIN' was not found in the remote database.
–
'END' was not found in the remote database.
–
–
The type string was not found in the remote database.
–
The version string was not found in the remote database.
The checksum failed upon entry into the remote database.
–
Based on the reason for the error (listed above), take the appropriate action.
Recommended Action
DHCP_SNOOPING-4-AGENT_OPERATION_FAILED
Catalyst 4500 Series Switch Cisco IOS System Message Guide
DHCP SNOOPING Messages
message.
2-17
Advertisement
Table of Contents
